How many inches from floor to bullseye Measurement for dart boards?

The bullseye should be 5ft 8 or 68 inches from the floor.

The Bullseye.

The height from the floor to the bullseye should be 173 centimeters (5 feet 8 inches). Hope that helped :)

The bullseye should be about 5 feet 8 inches from the ground. The throwing distance is also about 9 feet 9 inches.

100 points in a game of darts. 173 centimetres from floor to bullseye.

blow me

The floor of a house that is off the ground is first built with a layer of boards that is at a 45 degree angle to the load centers. To the average person, this layer of boards looks like a floor. However, they are wider than the boards than are normally used to go on the floor. The floor that people walk on will be put on top of these boards. The boards used for…

Generally twelve inches from the floor to center of the device is used.

The British Darts Organisation and the American Darts Organization specify that the distance along the floor from the plane of the board to the toe line (a.k.a. oche, which is pronounced like hockey with a silent H) is 7' 9¼". Also, the distance from the floor to the center of the bullseye is 5' 8". Rather than dropping a plum line to the floor then measuring along the floor, it is easier to measure directly…

25,000,000 km from the ground you need a really big house btw alright? have fun with hanging your new dartboard! your welcome for me telling you!

The Bullseye must be exactly 5 feet 8 inches from the floor and the toe line (where you stand to throw the darts) is 7 feet 9 and 1/4 inches from the board. Also see http://www.indepthinfo.com/darts/setup.shtml

from the floor to the centre of the bullseye, its 5 feet six inches ( 1.676 metres) the horizontal distance from the face of the dartboard to the back of the throwing line is seven feet, nine and one quarter inches (2.368 metres)

5 feet & 8 inches from the floor to the centre of the bullseye. 7Feet 9 and a quarter inches from the face of the board to the throw line or "oche" For Soft tip darts 8 feet from the face of the board to the throw line or "oche"

The center of the bulls eye is 5' 8" from the floor.

In the standard game, the dartboard is hung so that the bullseye is 5 ft 8 in (or 173 cm) from the floor

Standard height from the floor to the bullseye on the dartboard is 5 feet 8 inches, while the oche (distance between the front of the board and the toeline) should measure 7 feet 9.25inches.

Standard is 12 inches to the center of the pipe from the finished wall.

Steam cleaners do not lift varnish or shrink polished floor boards. The whole idea of applying varnish to a floor is so that the floor will be protected from moisture or liquid being absorbed by the wood.

5'8" from the floor to the CENTER of the BULLSEYE is the height. 7'9.25" from the FACE of the board is the throw line.

The boards or other material of which a floor is made.

Fritz Pfeiffer and Anne Frank's room inside the secret annex measured 16 feet 7 inches long by 6 feet 10 inches wide. The measurement from floor to ceiling was 9 feet 4 inches.

answer You would lay timber floor joists acroos the the size would depend upon how high you need to raise the floor. Then you'd lay floor boards over the joists. the joists would be layed every 400mm and would require noggings to reduce movevement and 'creaking'. The floor boards should be of a tongue and groove type for the same reasons. The cheapest floor bords are made of chipboard and are 8' by 2' and…

If the shed is made from 150x 100=3x2 framing with a half inch boarding by adding 7inches to length and 7 inches to the width on to the internal measurements it will be the correct size. So if you're taking an internal measurement for a base you need to measure the thickness of your wall double it and ad to your internal measurement. Hope this helped you.

In your house on your floor like tile or boards

The height of a regulation dartboard is 5'8" from the center of the bullseye to the floor, with a toe line at 7' 9.5".

Lineal metres = Square metres/Width of the boards.

The floor boards contract when it gets cold. The noises you hear are the floor boards contracting.

Assuming you are laying the boards flat, you will need 137 boards if you leave no gaps between them.

under the floor boards

There are no had rules. The shape of the room has a lot to do with what will look best. Running the boards the direction of the greatest floor length means fewer short boards which can make the floor look choppy.

To determine the length of gold club needed for a person who is 6 feet tall the person must measure the distance from their wrists to the floor. They should stand with their knees bent slightly and their hands at their belt buckle. The average person has a measurement of 43 inches and they should choose a golf club that is 1 or 2 inches from this measurement.

Yes but lay the recommended underlay first!

lilycove megamart (clear out - sale)

convert the 5'X6' to inches and you will have your answer

That depends on (a) the mass of amount of pressure applied by the tonne - how much area does it occupy and (b) the strength of the joists - the boards the floorboards are laid across. it also might depend on whether the floor is at ground level or not.

Hollow to Floor measurement is simply from the hollow of your neck to the floor by your feet. This measurement can be used by a company to determine how long to make a dress. If you are wedding dress shopping and are shorter than the average human, this measurement can be given to the manufacturers ahead of time to make 100% positive that the dress will be in your height. Be warned... if you are…

The measurement of ocean depths and the charting of the shape or topography of the ocean floor. Bathos= Depth metry= Measurement

You generally cannot. The boards are a veneer of a picture of wood.

Under BCA and APA ules, a table surface must be between 29 1/4 inches and 30 1/4 inches from the floor. This is measured by placing a flat edge or yardstick across the corner. The height from floor to bottom edge of the straight edge is measured. Then the height from surface to straghtedge is measure and subtracted from the first measurement. This result is the height of the table.

Joist possibly ? A joist is the boards under the floor and above the ceiling that span the room or building. What the floor or ceiling is attached to.

10 feet even

with the cork from a tree you can make bulletin boards, floor tiles wine stoppers, etc.

nothing. everything was placed under Bella's floor boards.

Standard wood floor joist spacing is 16" on center.

The top of the hoop is 10 feet above the playing surface below and measured perpendicularly. The bottom of the backboard is 9 feet 6 9/16 inches from the floor (The lowest point) The vertical dimension of the backboard: 42 to 48 inches. The very top of the back boards described: 51' 6 9/16" to 57' 6 9/16". The rim is 10' off the floor.

....pull up the floor board, unless you can see them then try using wire to make something to pick them up with.

Look in areas such as under sills, floor joists, skirtings (kick boards ) and especially around areas of the house where it touches the floor

Meter measurements are the distance from the floor to a common doorknob.

An average bed height today is 25 inches off the floor with platform beds being about 18 inches off the floor. Antique beds are quite a bit higher, averaging 36 inches off the floor.

either convert the feet into inches or the inches into feet