Straight 6 cyl and v-6 cyl engine both take 5 quarts of oil. If you change the filter, add 1 extra quart. joedi
Should be a dipstick towards the firewall usually with a red handle. Check it when the transmission is warm and the engine has to be running.
Yes, fill the transmission fluid through the dipstick tube and it takes approx 5 & 1/2 quarts of trans fluid.
It depends on where it is on the stick. The full mark should represent 5 quarts of oil. The add mark means you are a quart low (4 quarts)
3 quarts,.. depending on the level of oil the dipstick displays..
4.3 L V6 takes 5 quarts of oil (5W-30), give it 5 quarts then start the truck let it run for a few minutes and check the engine oil dipstick with the engine off.... Your dipstick should never actually read "full" though. technically the 4.3L tells you it is 4.5 quarts (calculate the 4.3L and you get 4.5 quarts)
5 or 6qts after 5 check dipstick add 1/2 qt at a time check dipstick again till full
The rule of thumb is about 4 quarts, if you just changed your oil. what you should do is add about 3.5 quarts, check the dipstick and add the rest if needed.
Your 1992 Toyota transmission will hold 12 quarts of transmission fluid, when it is empty. You can check the transmission fluid level with the dipstick.
The engine should hold approximately 3.5 quarts of oil. Add 3 quarts then keep checking the dipstick until the engine shows full.
should be 3.5 quarts. put in 3 and the level should be halfway down the "ok" range on the dipstick. Top it off accordingly, not forgetting to account for how much oil the filter holds
depends on the motor size but it should be somewhere around 5
The seats should be the same.