== ==
It's a 4 speed front wheel drive transmission with electronic sensors for shifting.
The Mitsubishi Montero is available to test drive at the Mitsubishi dealer. Call your local Mitsubishi dealer to take an appointment in order to test drive the Montero.
The slave cylinder for a manual transmission hydraulic clutch is inside the manual transmission bellhousing
Input Speed Sensor is on Front of Trans closer to the engine. Output is on the front, farther to the drive side. Both are two wire sensors.
Something small with a 4 cylinder engine and a standard transmission.
To replace the slave cylinder on this vehicle you will have to remove the drive shaft and then the transmission. The slave cylinder will be bolted to the inside of the bellhousing. The transmission is very heavy so be very careful.
The sensor is located in the tail shaft housing of the transmission (where the drive shaft attaches to the transmission). It screws into the housing and has a two wire plug on it. hope this helps
it has sensors either on the wheel hub or in the transmission to check for distance traveled while in drive
What about it?
Cylinder 1 is @ the drive belt side of the engine(passenger side), and Cylinder 4 is closest to the transmission side of the engine(driver side).
no it is not. the bolt pattern on the back of the engine where the transmission bolts up is different. the cavalier is front wheel drive, the s-10 is rear wheel drive
Something small with a 4 cylinder engine and a standard transmission.