That depend on the amount of sunlight the amount of use the pool is getting and the amount of bio- material suspended in the pool. The best thing to do is to test the pool and follow the instructions on the test kit or take a sample of water to your pool shop and ask them for advice.
about 3 oz.
Generally, you would need about 2-3 pounds of chlorine for a 1000 gallon pool to properly sanitize it. It's important to follow the manufacturer's instructions and recommended dosage for the specific type of chlorine you are using.
The amount of chlorine needed for a pool depends on its size, level of usage, and current chlorine levels. A general guideline is to add 2-4 ppm of chlorine to a pool, which can typically be achieved by adding 1/2 gallon to 1 gallon of liquid chlorine per 10,000 gallons of water. It's important to test the water regularly and adjust the chlorine levels accordingly.
To maintain proper chlorine levels in a 1000 gallon pool, you would typically add around 0.8 to 1.5 lbs of chlorine granules or tablets per week. It's important to regularly test the water and adjust the chlorine levels accordingly to ensure proper sanitation.
Gas is more of an everyday purchase now than it was in 1930. In 1930, a gallon of gas cost ten cents.
Depends on how much is already in the pool and the concentration of the liquid chlorine. IF you are just staring out, try using a half a gallon and measure with an OTO tester after a couple of hours. You are shooting for a minimum level of 1 PPM chlorine and 7.2 pH. Hatawa
ppm = lbs Chlorine / lbs of water given: 1 ppm = 1 x 10e-6 1 gallon of water = 8.33 lbs 1 lb = 454 grams Therefore; 4x10e-6 = lbs Chlorine/(3000 x 8.33) lbs Chlorine = 4x10e-6 x 3000 x 8.33 lbs Chlorine = 0.09996 or 0.09996 lb x 454grams/lb = 45.38 grams 4ppm of Chlorine in a 3000 gallon pool is: 0.09996 lbs which is about 45.38 grams
how much chlorine do I put for a 1,718 gallon pool
NONE! ZERO! NADA! Never put chlorine in your fish tank. You want to remove chlorine from your tap water before using it in your tank.
You'll need about 240 pounds to start, to get chlorine level to correct amount
To shock the pool, about a gallon. To just chlorinate, a quarter gallon, then measure the chlorine level with an OTO test kit. Keep the chlorine level between 1-3 PPM, and the pH at 7.2. You can adjust pH with plain old baking soda if the pH is too low, or add a little muriatic acid if the pH is too high.
For a 5,000-gallon pool experiencing a chlorine lock, you typically need to add about 1 pound of shock (calcium hypochlorite or sodium dichlor) for every 10,000 gallons of water. Therefore, for a 5,000-gallon pool, you would use approximately 0.5 pounds of shock. It's essential to check the chlorine levels with a test kit before and after shocking to ensure proper balance and effectiveness. Additionally, consider addressing any underlying issues contributing to the chlorine lock.