Water weighs 8.34 lbs per gallon, so 10 gallons would weigh 83.4 lbs.

🙏

0🤨

0😮

0😂

0Loading...

83.4 lbs - excluding the weight of the bucket !

milliliter

A bucket of sea water is heavier. The density of seawater is just over 1 gram/milliliter. The density of oil is less than that, meaning the same volume of each liquid has a different mass.

liters

litre

If you poor out some of the water in a bucket does the density of water change?

A normal bucket can hold up to 10 litres.

How large is the bucket? I would suggest pouring water in to find out.

The bucket has a capacity of 10 litres.(Correct spelling is capacIty)

what is the effect of placing an object with a greater density than water in a bucket of water

Gallons

Clay

In general and easy terms, Struck Capacity is the capacity of material present in a bucket of any Excavating Equipment.

That is 9,700 ml.

Starting from 8 lit upto 25 lit capacity buckets are available.

It should be around 83.3 pounds

5 gallons

It all really depends on what size the bucket is that's holding the ice. You would have to find the capacity of the bucket first.

Litres is better to measure quantities larger than a quart.

It all depends on the size, material and maximum capacity of the bucket in question. It helps to be more specific with questions like these.a 2.5 (10 Qt.) bucket will weigh about 20 lbs., a 5 gallon bucket about 40 lbs.

The capacity of a pail (bucket) is usually given in litres. The capacity of older buckets still in use might be in imperial gallons.

Usually liters

Depending on the volume of the bucket; for 20 L the weight is 20 kg because the density of water is 1 g/cm3.

Assuming all three are relatively normal compared to each other (large bath, medium bucket and small bottle), then the bath will hold a good deal more fluid than either the bucket or the medicine bottle, and therefore has the largest capacity. However, if capacity is measured against the amount of fluid they already contain and they're all full, then they all have the same capacity: none at all.

you use the 4 litre bucket to feel the 9 litre bucket then empty the 9 when it is full till you end up with 6 in it as follows you put 2 buckets of 4 into 9 then 1 litre from 4 to fill 9 then empty 9 put remaining 3 into 9 put 4 more in then 2 to fill 9 and empty put remaining 2 in then 4 more giving you 6 litres ---------------------------------------------------------------------------- My way: (Mechanical Engineering Student) Take the 9l bucket filled to capacity and use it to fill the 4l bucket twice leaving you with 1l remaining in the 9l bucket. Next, pour that 1l into the 4l bucket. Fill the 9l to capacity again. Using the 9l bucket fill the 4l bucket to capacity leaving you with 6l total in the 9l bucket.