about 10to 12 pounds
If we are talking about 4' x 8' sheets, the answer is more like 45 pounds, although it can vary quite a bit by type of wood used, grade and interior versus exterior.
Approximately 25lbs for every 1/4 inch of thickness of a 4' by 8' sheet.
Plywood weighs a lot or a little depending on the amount of plywood being discussed. A quarter inch sheet of plywood that is 4 x 8 feet will weigh approximately 22lbs.
Generally, figure on 25 lbs per 1/4'' x 4' x 8', so approx. 50lbs
A full 4'x8' sheet or 3/4" plywood weighs 68.16 lbs.
About 75 lbs
about 50lb
45 lbs
245 lbs
245 lbs
The answer depends on the type of wood used (different woods have different density levels) and whether or not you mean a full sheet (4' X 8').
when asking this question you first need to take into account that plywood comes in different thicknesses therefore weight per particualr thickness of sheet plywood will vary-- in my opinion/ without fact and research / a sheet of 1/2 inch plywood may way about 16 lbs. while a 3/4 inch plywood sheet may way 70 lbs.
A 4x8 sheet of 1/2 inch standard weighs apptroximately 52 pounds. The new 'Light ' board wieghs about 34 pounds.
No, not safe; if supported on each end it is likely to break
A half inch thick steel plate, A half inch thick plywood, Brick, Concrete Block
One sheet of the new 'Light' 4x8 x 1/2 inch is about 32 pounds. The old one (probably still sold in some areas ) is 54 pounds.
It depends what the "ply" value is ... the number of layers glued together. For instance, 1/2" plywood is going to be lighter then 3/4" plywood. A common rule of thumb is a 4x8 foot sheet of 1/4" fir plywood weighs 25 pounds. There are 32 square feet in a sheet, so a square foot of 1/4" fir plywood weighs about 0.78 pounds. Since 1/2" is twice as thick as 1/4", 1/2" fir plywood weighs twice as much, or 1.56 lbs, and 3/4" three times as much, or about 2.34 lbs. Fir plywood is common, but other species are available. Weight varies considerably between species of wood, so be aware the weight of plywood of different species can be different.
Use a saw.
A rule of thumb is 25lbs per 1/4" of thickness, so for 3/4" would be around 75lbs.
Anywhere from 60 or 66. Depends on the mill it came from
that depends on the type of plywood 3/4" ranges from about 20.00 to about 50.00 a sheet (cheap flooring to higher end finish plywood and marine grade pressure treated) in my area. . .check around.