0
What else can I help you with?
Where do you add brake fluid in a 1990 Mazda protege?
To add brake fluid in a 1990 Mazda Protege, you need to locate the brake fluid reservoir and check the levels. The reservoir is located on the master cylinder for the brakes.
How do you replace third brake light 2002 Mazda Protege?
To replace the third brake light on a 2002 Mazda Protege, first, open the trunk and locate the plastic cover for the brake light assembly. Remove the screws or clips securing the cover, then gently pull it off. Disconnect the old light bulb by twisting it counterclockwise, replace it with a new bulb, and reassemble the cover by securing it back in place. Test the brake light to ensure it's functioning properly.
How do you replace the rear brake pads on a 2001 Mazda protege?
To replace the rear brake pads on a 2001 Mazda Protege, first, lift the vehicle and remove the rear wheels. Next, locate the brake caliper and remove the bolts securing it, then slide the caliper off the rotor. Remove the old brake pads and replace them with the new ones, ensuring to compress the caliper piston if necessary. Finally, reattach the caliper, secure it with the bolts, and reassemble the wheel before lowering the vehicle.
Where is the brake light switch for the 1997 Mazda protege?
Above the brake pedal,its black plastic.
02 Mazda pro 5 e brake cable loose?
HOW DO I TIGHTEN EMERGENCY BRAKE CABLE ON A 2002 MAZDA PROTEGE 5?
Where is the fuel filter for 96 Mazda Protege?
Next to the master brake cly.
What is minimum brake pad thickness for a Mazda Protege?
about 5mm then after that they will get hot and squeak
Brake fluid 2000 Mazda Protege?
this is a guess but most Proteges use DOT3
Where is the brake proportional valve located on a Mazda Protege 1995?
behind the engine on the firewall
Your brake light sw is working and your brake lights still remain on for your 1992 Mazda Protege?
Switch is defective or out of adjustment.
How do you replace the brakes on a 2002 Mazda Protege EX?
To replace the brakes on a 2002 Mazda Protege EX, start by lifting the vehicle and removing the wheel to access the brake assembly. Unscrew the caliper bolts, then carefully slide the caliper off the brake rotor and support it without stressing the brake line. Remove the old brake pads, install the new pads, and compress the caliper piston if necessary. Finally, reassemble by sliding the caliper back over the new pads, tightening the bolts, and replacing the wheel.
How do you disassemble the rear brake light cover so you can replace the brake light bulb on an '03 Mazda Protege 5?
You have to go inside the trunk and remove the circular plastic covers from behind the lights. Then you have to unscrew the entire light and you can access the bulbs to replace them.
