answersLogoWhite
Fuel and Fuel Intake
Air Filters and Intake Manifolds
Chevy 350

How much torque should be aplied for the intake manifold?

272829

Top Answer
User Avatar
Wiki User
Answered
2007-01-23 17:06:22
2007-01-23 17:06:22

Torque values are only listed in the vehicles repair manual or service manual and vary depending on year, make, and model.

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


diferential pressure sensor intake manifold plausibility



What are the intake manifold torque specs on 1998 Oldsmobile bravada?"


what are the torque specifications for 2002 ford 4.0 intake manifold


The 350 cubic inch Chevrolet intake manifold bolts have a torque specification of Haiti pounds psi. The bolts should be torqued at 40 pound intervals.


The 1997 Buick LeSabre intake manifold bolt torque specifications is 45 pounds per square inch. The manifold bolts should be torqued in 15 pound intervals.


The 1997 Mercury Cougar 4.6 liter engine intake manifold torque sequence should begin at each end of the manifold. Keep moving towards the center and alternating from and to end.


Intake manifold torque specifications for the Olds 403 is listed as 30 ft-lbs.


What are the torque specs for 99 ford ranger 3.0L intake manifold?


Bstuff.com should have the info you are looking for.


what are the torque specs and sequence for a 1992 Nissan maxima manifold


Intake bolts should be torqued to 35 ft lbs in the appropriate sequence. There should be 12 total "intake" bolts


What are the intake manifold torque specs for a 1998 ford f-150 xlt



Intake Manifold torque is 30 ft/lbs on the 460 Ford V8Valve cover is 10 ft/lbs


The 1999 Pontiac cylinder head gasket bolt torque specification is 160 pounds. The intake manifold bolt torque specification is 90 pounds.


The torque specifications, for a 4.3 liter engine manifold, is 45 pounds per square inch. Torque the manifold bolts in 15 pound intervals.


1996 chevy c1500 pick up 305 motor bolt torque spec intake manifold


boxwrench.com they got alot of torque specs on there



torque for bolts upper intake 1999 ford taurus 3.0 dohc


Intake Manifold (Cast Iron Heads) Non- Hardening Sealer 30 ft-lbs.


Intake Manifold (Cast Iron Heads) Non- Hardening Sealer 30 ft-lbs.


There is no torque spec for the air filter --it sits in its housing which snaps open and closed.The intake manifold torque specs are 89 inch pounds (7.5 ft.lbs.), that is for both the upper and lower intake.


torque specs. on chevy sub for a 5.3L intake manifold and tighten sequence NEW ANSWER; step 1 is 44in-Lbs. then step 2 is 89in-lbs. That's it.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.