How remove the radiator from 2003 Chevy Impala?
i need a step by step instruction on how to remove or replace a radiator of a 2005 3.4L chevy impala
I have know idea
do you need to remove dashboard in 2003 chevy impala to replace heater core
Drain the radiator, disconnect the hoses, unbolt the radiator, and lift.
The thermostat should be on the top of the engine under the water inlet. Drain the radiator. Remove the top radiator hose from the inlet. Unbolt the inlet, and pull the thermostat out for replacement.
should be similar ...... http://www.justanswer.com/car/3trf2-radiator-drain-plug-2003-chevy-impala.html
Remove the tire and wheel from your 2003 Chevy Impala. Remove the brake assembly spring and the break caliper. The brake pads will come off. Reverse the process to install the new brake pads.
check radiator cap for wear. defective cap can cause radiotor hoses to collapse.
It does not have a governor. Speed is controlled by the computer ECU which you cannot remove nor reprogram.
Drain the radiator into a container. Remove the upper radiator hose at the engine. Remove the2 bolts on the thermostat housing and lift it up. Remove the thermostat and clean the surfaces. Install the thermostat and the bolts. install the top radiator hoes and fill the radiator.jd
The 2003 Chevrolet Impala radiator drain plug can be found on the right hand side of the radiator. The radiator drain plug will be at the bottom of the radiator.
It is beneath the lower radiator hose.
there should be little screws that you screw out and they pop out and you twist the bulb to remove it
Drain enough of the radiator to remove the top radiator hose. Remove the hose, then the pipe that the hose connects to. The bottom end of the pipe houses the thermostat.
The 2003 Impala has a 17 gallon fuel tank
You may be low on coolant or there is an air pocket trapped in the system, also be sure the radiator cap is good.
It is located just below the lower radiator hose.
check with your Chevy dealer on that.
how do you replace a transmission pressure control solenoid in a 2003 chevrolet impala
Drain the Cavaliers radiator. Remove the top radiator hose, and the inlet pipe. Take the thermostat out from under the inlet pipe and replace it. Reinstall the pipe and hose, then refill the radiator.
It is just below the lower radiator hose.
Near upper radiator hose ...at end
Fix a "door ajar" on Chevy Impala 2003 . Still on doors closed.
There is not drain plug, you need to remove lower rad hose.
In the fuel tank
is there a drain plug on the radiator
The drain plug on the 2003 Chevy Venture is located on the bottom edge of the radiator. It is on the side facing the engine.
It requires a special puller and it is located on the front of the engine. It will require pulling the radiator and fan. You will need an air wrench to remove the bolt.
Check with your local Chevy dealer on that.
To change a thermostat on a 2003 Chevy Impala remove the connectors to the battery, wait for the coolant system to be drained and take out the radiator hose. Remove the thermostat and clean it's component, position the thermostat, put the new gasket on top of the thermostat and put engine oil on the bolts. Attach the radio hose and fill the system with coolant. Put the negative part of the battery cable to the… Read More
where is oil sending unit located on 2003 chey impala 3.8 liter
Went to home depot, had a key made for a dollar. Works great in my 2003 impala, 3.4.
The RPM is not working on 2002 chevy impala LS. transmission and engine sounds good- no problem. what's wrong
one is a Chevy and one is a Chrysler, you do the math.......
there is no drain plug
Any engine that the 03 Impala came with takes 4.5 qts.
the radiator drain plug is on the bottom right facing car from front. you may have to remove the sheild to get at it. my 2000 malibu uses a allen wrench to loosen the drain plug for the radiator. good-day !
The radio on a 2003 Chevy Impala can be typically be fixed by replacing the fuse. If the radio does not work when powered, it will need to be replaced with a new unit.
My 2003 Impala LS has 42000 miles, I average about 16MPG in the city and 23 highway.
stuck thermostat or a air bubble in the system. Or the lower radiator hose is plugged or collapsed.
There is not a reset switch.
Through the dipstick tube
behind the brake pedal.
it is 225/60/R16
18 or 20 gallon.
Every 10,000 miles
20" IS GOOD. ANYTHIGNG BIGGER AND U'D HAVR TO REMOVE THE PROTECTIVE COVERING INSIDE THE WHEEL WELL
intake gasket, leaking radiator and radiator cap, leaking heater core,, air in the sytem that needs to be bleed by the bleed screws,,,but most of all on all these cars with the 3.8 or 3.4 are bad about intake gaskets,,hope this helps
you have to remove the belt tensioner to remove the belt off of the engine.
Check to see if you are getting power to fan motor turn on A/C or defroster If you are getting power to fan - then fan is defective If not check fuse Could be temperature sending unit in radiator