answersLogoWhite

0

When the light comes on it is your atv's way of telling you that the belt needs to be checked and probably adjusted. Take it back to your dealer and have them check and adjust the belt and they will automaticly reset your light. the reset procedure is similar to 650 700. Unplug 2 pin conector going to belt switch. Unplug black conector under seat , unplug white conector beside it ( white plug is a reset plug which has no wires conected to it from machine) Plug reset plug into black plug turn key to on , turn off. plug everything back to stock. You are done."

1) remove seat, unplug black and grey 4-pin connectors

2) swap plugs, grey to black and black to grey

3) turn on ignition switch, belt light should be flashing quickly

4) disconnect 2-pin belt switch above torque converter cover, belt light should be flashing slowly

5) let flash for at least 5 seconds

6) turn off ignition switch

7) reconnect 4-pin connectors black to black and grey to grey, reconnect 2-pin belt switch

turn on ignition switch to confirm belt light is out this answer is wrong disconect 2 wire switch on cover only connect grey male to blk female then switch on

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you tighten belt on kawasaki brute force?

how do u tighten belt on brute force 750?


How do you stop light flashing from 2WD to 4WD on a 2006 kawasaki 750 brute force?

fix your kebc on belt hosing or bypass it


Are there timing marks on the flywheel of a kawasaki 750 brute force?

Yes, the Kawasaki 750 Brute Force typically has timing marks on the flywheel, which are used to align the timing during maintenance tasks such as valve adjustments or timing belt replacements. These marks help ensure proper engine timing for optimal performance. Always refer to the specific service manual for detailed instructions and diagrams related to your model.


Why does a belt break on a ATV kawasaki 650 brute force?

its probably from going threw mud in 4 high and or also from pulling people out in rev so if you can go in 4 low when in mud and just use you winch to pull out other people.


Kawasaki 2003 650 v twin ATV how to reset belt light?

Winch cable goes in but will not come out?


How do you reset the slendertone belt?

How do you reset a slendertone belt.


How do you adjust the drive belt on a 610 kawasaki mule?

Take it to your nearest certified Kawasaki dealer...


How do you reset the timing belt on Toyota 2kz 2oo6?

You do not reset a timing belt you replace it.


How you reset timing belt light on 2008 land cruiser?

what the prucedure timing belt reset


2002 landcrusier timing belt light reset 1hz?

how do i reset timing belt light on 1hz


How do you reset timing belt?

Timing belts are replaced, not reset.


Kawasaki 59011-1051 belt cross reference?

need john deere belt H86061 cross reference