its the red one conected to the positive terminal
Remove the cover on the fuse box by pressing the tabs on either side, then find the remote positive terminal. Attach your red jumper cable to the terminal and the +ve terminal of the charged battery and the black cable to the -ve terminal of the charged battery and the -ve battery terminal or the chassis of the car to be jumped.
Disconnect the negative cable FIRST!..then disconnect the positive and remove.
Disconnect the negative battery cable and then remove the positive cableRemove the battery heat shieldRemove the battery hold-down clamp boltLift out battery
connect the positive (red) cable first then negative (black)
To jumpstart a 2003 Mercedes-Benz S500, first locate the battery, which is in the trunk. Open the trunk and remove the cover to access the battery terminals. Connect the positive (red) jumper cable to the positive terminal of the dead battery and the other end to the positive terminal of the donor battery. Then, connect the negative (black) jumper cable to the negative terminal of the donor battery and attach the other end to a metal ground point on the car with the dead battery, avoiding the negative terminal directly to prevent sparks.
Follow the positive battery cable from the battery. It will lead you directly to the starter. Driver side of the engine, below the exhaust manifold.
On a 2003 Honda FourTrax 350, the positive battery cable connects to the positive terminal of the battery. From there, it typically runs to the starter motor and may also connect to the main fuse and other electrical components. Ensure that the connection is clean and secure to maintain proper electrical function.
Fusible Link
To replace the battery cables in a 2003 Chrysler PT Cruiser, first, ensure the vehicle is off and the keys are removed. Disconnect the negative (-) battery cable first to prevent any electrical shorts, followed by the positive (+) cable. Remove the old cables by loosening the terminal clamps and replacing them with new cables, ensuring a secure fit. Finally, reconnect the positive cable first, then the negative cable, and check that everything is tight and secure.
To jump start a 2003 Dodge Intrepid, first, ensure both vehicles are turned off. Connect the positive (red) jumper cable to the positive terminal of the dead battery, then attach the other end to the positive terminal of the working battery. Next, connect the negative (black) cable to the negative terminal of the working battery and attach the other end to a grounded metal surface on the Intrepid, away from the battery. Start the working vehicle and then attempt to start the Intrepid.
Remove battery cover and connect charger to side post battery.
2 is positive