Isuzu Trooper
Nissan Pathfinder
Crankshaft Sensors
Ford F-350
How To

How to locate a cam position sensor for a 88 trooper?

464748

Top Answer
User Avatar
Wiki User
Answered
2006-09-19 19:47:29
2006-09-19 19:47:29

it's built into the distributor

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


the cam sensor is locate at the front of the engine.

You locate cam-sensor check for loose or broken wires ,if this doesn't work replace cam-sensor.

No crank sensor, only a cam position sensor.

If you mean crank position sensor it's on the back of the engine, forward side. If you mean cam position sensor, that is taken from the distributor, there is no separate cam sensor.

Crank sensor is in the top of the transmission housing at the back of the engine. Cam position sensor is in the distributor.

Cam position is taken from the distributor, there is no external cam sensor.

The cam position sensor signals the fuel injectors to inject. The crankshaft position sensor signals the spark plugs to fire.

Cam position is taken from the distributor on this vehicle, there is no separate cam sensor.

Camshaft position sensor intermittent.The cam sensor on the end of the head has failed.Camshaft position sensor intermittent.The cam sensor on the end of the head has failed.

CMP= Cam Shaft Position Sensor.

The cam sensor is inside the distributor.The cam sensor is inside the distributor.

The 94 and 95 are the same,no cam sensor.1996 and 1997 are differant in one way.The 1996 and 1997 have a cam sensor. .The 97 has a cam sensor and the 94 does not.The 1996 has a cam sensor too.

The cam position sensor is attached to the distributor, under the distributor cap. It is held in place with two screws.

To change a 305 cam sensor, locate it beside the camshaft. Disconnect the electrical plug of the sensor and remove the hold-down bolt to take off the cam sensor. Replace with new.รŠ

cam sensor senses position of cam .coil sensor operates coilboth 2 entirely different parts of engine

I would like to know where the cam sensor is on a 1999 pathfinder and is there one or they calling it a crank shaft sensor The cam shaft position sensor is located in the distributor.

Cam position is taken from the distributor, there is no separate sensor near the cams.

The 2003 Saturn L200 does not have a camshaft position sensor.

Cam sensor, thats about it, there aren't any other names for that sensor.

Never heard of an "ignition sensor". Do you mean oxygen sensor, or maybe crank position sensor, or cam position sensor? There is an ignition "module" also... The oxygen sensor is on the exhaust manifold. The crank posiiton sensor is on the backside of the block. The cam position is on each head.

Cam position is taken from the distributor, there is no external cam sensor.

Cam position is taken from the distributor. There is no separate cam sensor.

There is no cam sensor on the 1995 year engine. GM. did not use a cam sensor on that year.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.