to get to the latch rod you will need to pull the plastic trim fasteners from the door and take the screws out of it on the bottom of the door. Pull the trim out just far enought to go thuought the top access hole after you cut a hole in the plastic vapor barrier and the latch rod will be just a few inches to the right pull up and the door will open.
Replace any broken parts or adjust latch assembly
You remove it from the door and find exactly which part is broken,replace that part.
It is very easy to repair a broken glove box latch. Once you've acquired the part, you will need to take the inner and outer panels of the door apart. The latch is attached to the outer panel of the door. It can be removed with a couple of screws.
depends on the problem, it could be the hood release cable, or the latch. latch is very simple, the cable is also simple, just more of a routing problem.
dodge truck broken hood latch
How do you open the hood latch from the outside on a subaru impreza
If the door latch on a 1999 Chevrolet Blazer is broken on the car frame, a new latch might have to be welded in. The old door latch will have to be cut out with a torch. If the latch is broken on the door, a new door might be cheaper than welding in a new latch.
To fix the 300m latch, you will need to remove the inner door panel. After the door panel has been removed, then you can check the door latch components to determine what has broken and how to best repair it.
Roll down the window, reach outside, and lift the door latch or lever.
How to repair the rear door latches on my e 350 van. The bottom latch will not hold . How do I get the latch to hold Thanks
there is aq clip whivh is located on the rod going from the door handle to the door latch just find the clip and put back in is broken like mine i made a clip and it has not broke since.
You have to take the inside handle apart to activate the latch manually. If you can't do it from the handle area you have to remove the inside door panel.
ideaswill it open from the outside and not the inside if so then it's a child safety lock located on the door jam near the latch if not you could have any of the following broken lock, door latch or the latch is just stuck.
If the trunk on a Honda Civic will not close the locking mechanism may be jammed. Be sure to remove any obstructions on inside the trunk latch. If the latch is broken replace it.
what is wrong with the door latch? will it not open/latch? what year is the vehicle? all of these are needed to answer your question.
Use a set of pliers to pull the cable even if the plastic latch is broken...
With a pair of pliers pulling the latch.
left door latch is broke
Need more information. Is the latch behind the grill broken? Or is it the latch operated from inside the vehicle? If it's the latter you can remove the latch mechanism and pull on the cable using pliers or vise grips.
If you remove the grill from the front of the truck you can then access the safety latch and hood release. My latch had rusted so I had to do this using a flat head screw driver and lifting the safety latch which allowed for the hood release to open.
you can get to the latch through the grill
how can i repair a 94 chevy k1500 tailgate latch. cannot open gate
I assume you have tried opening it by pulling the hood release lever. Determine the cause of the hood not opening. If the release handle for the hood doesn't retract back into position after you pull it, it's likely that the cable leading to the latch is broken. If the release handle retracts as usual and you can feel it trying to release the latch, it may be the latch itself that is broken. It is more common for the latch to be broken or jammed than for the cable to be broken. Rule out the hood being jammed shut before you proceed as if the latch is broken. Have another person stand in front of the car and pull up on the hood while you stay inside the car and pull on the hood release cable. This may help unjam the hood if that is the problem. If this still doesn't help the hood lift up, you can proceed as if the latch unit is broken. Shine a flashlight through the front grill of the car to locate the latch unit. Once you can see it, use a screwdriver to go through the front grill and manipulate the screwdriver in different ways, trying to open the latch. The latch is spring loaded, so it may take pressure to open the latch manually. Be careful to stay away from the condenser for the air conditioning unit--the screwdriver could puncture a hole in it if you don't keep it only on the latch assembly.
How do you repair drivers side door latch mechanism on 98 GMC extended cab pickup?
you have to go on the fan blades of the mill and spin them counter clockwise