A 2002 Chrysler Sebring has an overhead cam engine. That means it does not have push rods.
NO, Dodge doesn't have a reset button.
You push the close button.
My 2002 Chrysler Sebring has 154K miles on it and the front end rattles when it goes over bumps. When I jack the car up and push in and out and side to side on the wheels their is no movement. Nothing seems to be lose when I pull on the front end. I had the same problem on my 2002 Sebring Lxi Sedan. Problem was worn swaybar linkage and bushings. I had the linkage and bushing replaced and the rattling disappeared.
Push the snowflake button.....the button has a little light that lights up when you push it so you know it is on....
Examine fan belt.
Isn't it the same as the 2008? Simply push the door in to release it and again to close it....
Push the flasher button. It will have a triangle symbol on it.Push the flasher button. It will have a triangle symbol on it.
To reset the oil warning light on a 2008 Chrysler Sebring, turn on the ignition without starting the engine. Slowly push the accelerator down three times. Next, turn the ignition to the lock position and the warning light should be gone.
There should be a "H" and a "M" on the console with a small hole beside each of them , use a pen to push the recessed buttons.. I own a 02`Sebring and I know this works as I have done it..
Get a toothpick and beside the clock there will be two indented buttons, one with a H other M, just take your toothpick and push in the button.
Locate fuse, pull old out, push new in.
On some Chrysler radios there are two round holes on the display panel of the radio with a letter h and m for hours and minutes. just take pen point and push into these holes to set the time.