Want this question answered?
What year tracer? Some you need special tool to pull bearings and hub as a unit!
There should be two on each side, outer and inner. There would be a big nut and cotter pin assembly that hold them inside the hub
You can replace both... Bearing or Hub... Bearings are cheaper, but harder to find and replace. Hub assemblies are easier to replace, but slightly more expensive.
how do you replace q front wheel hub on a 2006 ford 250 5.4 v 8 4 wheel drive
The front wheel bearing is a sealed unit with the wheel hub - replace the hub and wheel bearing unit. Remove the four bolts from the rear of the steering knuckle that connect to the hub bearing unit.
No, replace the entire hub.
the same way you would replace any hub assembly, take the wheel off, take off any bolts that connect the hub to the driveshaft and then replace it
Remove wheel. Remove grease cup. Remove caliper & secure it so it does not interfere with spindle. Remove brake disc. Remove hub nut. Remove hub & bearing assembly. Use a two jaw pulley to remove hub if you can't do it by hand. Reverse procedure to install.
The front wheel bearings must be pressed into and out of the spindle/hub assembly. You will need to take the spindle assembly to an automotive machine shop to have this done.
it is a 22m socket
Front or rear?
The wheel bearings are not really replaceable by themselves. This is because they are integrated into the hub assembly. So the answer is that you will have to replace the entire hub assembly to replace the bearings.