How do you reset check engine light for the 2009 Chevy trail blazer?
You can either bring it in to a Chevy dealer or use a programmer/tuner to reset the check engine light.
It requires an engine scanner to do that.
To reset the check engine light unplug the battery for 30 minutes. If the issues still persists the light will still light up when reattached.
That REQUIRES an ENGINE SCANNER to do that.
I reset the check engine light on my jeep by disconnecting it from the battery.
How do I reset the service engine light on a 2003 Chevy Trailblazer?
Fix the cause of the light coming on and the light will reset itself within a few drive cycles.
I have a 2006 Chevrolet C4500 Duramax Diesel and I would like to know how to turn off or reset the check engine light on the truck.
If you don't have a code reader you can disconnect the battery cable for a couple of minutes and that will reset the light
The check engine light is reset with a scan tool after repairing the cause of the fault.The check engine light is reset with a scan tool after repairing the cause of the fault.
Disconnect the battery for approximately two minutes.
Have vehicle scanned to determine the problem and have codes cleared
unhook the positive on the battery for 5 min. This should reset your check engine light if it doesnt then you still have issues.
You reset the check engine light with a scan tool after repairing the failure.
The check engine light has to be reset with a OBD scan tool
There are many reasons for that check engine light. You could go to dealership. Or you could simply disconnect battery and reconnect after 3 minutes.
Try disconnecting the battery for 10 minutes. May reset the light--if problem persists light will come back on
how do i reset the check engine light on a 1999 acura 3.2tl
on most vehicles if you disconnect the battery cables it will reset the check engine light
hoe do you reset the check engine light in a 1995 land rover
i unhooked the battery...(both terminals)
disconnect the negative battery cable for 30 seconds and reconnect it.
After repairing the cause of the code, you clear the code with a scan tool.
First you must fix the problem that caused the light to be set. You can try to reset the light by disconnecting the negative battery cable for five minutes. If that does not work you will need an 0BD2 scanner in order to reset the light.