The ABS light is on because there is a problem with the ABS system. Until the problem is fixed the light will remain on. After the problem is fixed the light will reset itself after a short drive.
The abs light is on because there is a problem with the abs system. The light will not go off until the problem is fixed.
The light is on because there is a problem with the abs system. Until the problem is fixed the light will remain on. Once the problem is fixed the light will reset itself afer a short drive.
You need to have the abs codes read, repair the cause, and the light will turn itself off.
you have to fix the problem or the light will just come back on until you do.
AnswerWhen light is on bring it to a shop that has an ABS scannerit happened the same to my 99 beetle i scanned it and the code came up to be abs pump, i replaced it with a used part but light still on. if you plan it to do it your self you need to be really prescise when thighing those line bolts i already screw one of them and had a leak, had to use the old block with the new pump.but my abs light still on. could be a faulty part. but i figured there is an abs relay on the firewall. will try that tomorow.
Take the vehicle to your mechanic. The abs (anti-lock brake system) light is on because there is a problem with the abs system. As long as the light is on the abs system is not functioning.
The light can not be reset without fixing the cause of the code that turned the light on.
The ABS light is most likely on because of low voltage, same reason for the battery light to be on. Get your alternator tested.
There is a problem with the ABS. It can be many things and a professional is needed to diagnose the fault.
Have the problem repaired and they will reset the light. If you DIY then disconnect the negative battery cable for 5 minutes. If that does not reset the light you will have to have it reset with an OBD2 scan tool.
There are several causes for ABS light to come on the 99 Sunfire. This may be due to worn or leaking master cylinder, contamination of brake fluid, or leaking brake hose.
You may have an ABS sensor going out at one of the wheels.
A person can reset the check engine light by disconnecting the battery. It can also be cleared by using an OBD scanner.
It means that the ABS control module has detected a problem in the ABS system. That will be impossible to determine without talking to the module with a scan tool to find out why it turned the light on. The other thing that it means is that you do not have ABS, but you now have conventional brakes. The ABS part of the brakes will not work until the problem is found out and fixed.
There are a number of reasons why your 99 VW New Beetle might be hesitating including overheating. Your Beetle might also have a leak in one of the fluids.
The air bag light is on because there is a problem with the air bag system. Until the problem is fixed the light will remain on. The light will reset itself once the problem is fixed.
IF the ABS light is on there has been a malfunction with the anti-lock brakes. Only the dealer or an authorized repair center will be equiped with the proper tools to check that light and the components in the anti-lock system.
These are standard bulbs you can buy at your local auto parts store.
could b your abs sensor in you front cv joint`s
99 percent sure there is NO oil reset procedure for the '97 sc models. If your oil light is on it is bc you are LOW on oil. Add oil immediately
Get your Anti-Lock Braking system diagnosed and repaired by a qualified professional. Then the light will turn itself off.
my 99 vw2.0 L beetle over heat
You need a OBD scan tool to clear any codes on this car.
Don't know if this works in a 99' but I have a 97'. You have reset the "oil life remaining" readout and this will reset "change oil" indicator. Scroll thru your various readouts (rpm's, water temp, battery volts, etc.) till you see it and then just press reset. Hope this works for you.