0
Although there is no mandatory size by rule, the butt of most pool cues is nearly the same. A typical diameter is one and 3/8 inches.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Can you fit a snooker tip in a pool cue?
No. The typical snooker cue tips are much smaller than the typical pool cue tips. So, you can fit a pool cue tip to a snooker cue, but not a snooker cue tip on a pool cue.
What were bumpers on cue sticks originally used for?
Until fairly recently, player's showed approval or a cheer for an opponents shot by pounding the butt of the cue on the floor. This was the pool room equivalent of clapping your hands.
What is the thing you hit the pool balls with?
The pool STICK,billiard pool stick or pool cue stick all refer to the stick that is used to play pool with
What is a McCormick pool cue?
It is a McDermott cue, McDermott is the largest manufacturer of pool cues, makes medium to very high quaility cue sticks
What do you call it when you twist chalk onto the tip of a pool cue?
It is called chalking the cue. The pool chalk is an abrasive, not chalk, and provides more frictin between the cue ball and the cue tip.
What is pool stick?
the cue
Is there a perfect pool cue?
No
Where can you get your cue weighted?
Most cues are made to be adjustable. The weight bolts are changed, added, or removed as needed from the butt end of the cue. Remove the rubber bumper from the butt end of the cue. If there is a weight well, then your cue is adjustable. If there is no weight well, then I would recommend you have a cue maker or cue repairman determine if your cue can be made adjustable.
What are cue cases typically used for?
A cue case is used for a pool cue. It is also used as a bag of sorts, because some come with a handle. It basically keeps the pool cue in good condition.
How do you build a pool cue shaft?
The simplest pool cue shafts are simply turned on a lathe following a template to produce the 13 mm or 14 mm tip, followed by the taper, and then to the mating surface to the butt. The proper mating insert is selected and the shaft is drilled and it is inserted. The tip is applied, the tip properly turned and shaped, and the shaft is complete. In most cases, the shaft is finished with the butt however.
Does the cue strike a cue ball horizontally?
No. There are almost no opportunities for the average person to have the cue contact the cue ball on the horizontal in a game of pocket billiards or pool. In nearly all shots, the butt of the cue must be raised slightly. And for most shots, cue ball control becomes an important part of the shot, requiring that contact be made off center as well, very often below or above center and not horizontally.
Can a pool cue shaft be made out of oak wood?
yes I am 99% positive that you can make a pool cue out of oak wood
