Best Answer

No tools required. Raise the hood. On the backside of the core support there will be two plastic strips behind each headlamp assembly. Pull upward on the strips for the affected assembly. When they disengage, pull slightly upward and outward on the assembly. Unplug wiring as desired and replace bulbs or the entire assembly. Headlight bulbs are 9005 and 9006's. To reinstall engage the lower tabs of the assembly in the slots in the core support, then push the two prongs through the square hole. Reinstall the strips and close the hood.

User Avatar

Wiki User

โˆ™ 2015-07-16 19:19:18
This answer is:
User Avatar

Add your answer:

Earn +5 pts
Q: How you change a headlamp on a 2003 GMC Sonoma?
Write your answer...

Related Questions

Where do you change the oil in a 2003 GMC sonoma ZR2?

In your garage or driveway!

Where is the IAT senor in a 2003 gmc sonoma?

where is the iat sensor located on a 2003 gmc sonoma truck

Where are the freeze plugs in a 1996 gmc sonoma?

Where are the freeze plugs located on a 2003 GMC Sonoma 4.3L Vortec engine?

What type of engine oil should be put into a 2003 GMC Sonoma?

I have a 95 Sonoma. I use 5W30.

What is the oil capacity of 2003 2.2 GMC Sonoma?

I am asking a qustion??

Do 95 GMC Sonoma have timing belt?

No, a 95 GMC Sonoma does not use a timing belt on it. The 95 GMC Sonoma uses a timing chain on it.

How much load can a 2003 gmc sonoma carry?

It is a half ton pickup ,correct?

Where is the low pressure port on a 2003 GMC Sonoma?

It's located right on the evaporator

How many mpg can you expect to get from a 2003 gmc somona?

Im getting 17.5mpg in my 2003 sonoma z-r2

How do you change headlamp bulb 2008 gmc Yukon?

you don't. take it to dealer and they will change it for free.

What year did General Motors come out with the gmc sonoma?

The GMC S-15 became the GMC Sonoma in 1991.

How do you change the blinker lights on the front of a GMC Sonoma?

Take the whole lens out

How do you remove factory stereo from 2003 GMC Sonoma?

you must first detatch all wires

Where is the horn on a gmc 2003 sonoma?

It should be mounted inside the passenger side front fender .

Where the timing connector on 95 gmc sonoma 2wd?

Where is the timing connector on a 1995 gmc sonoma

How do you change fuel vapor sensor on a 1997 gmc sonoma?

To change a fuel vapor sensor on a 1997 GMC Sonoma you need to disconnect the wires that are holding it in place. Next, remove the old sensor and replace with the new one.

Where do you plug in a 2003 Sonoma?

The spark plugs in a 2003 GMC Sonoma can be changed relatively easily with a socket wrench. However, the spare wheel must be removed from the wheel well to allow access.

What is bolt pattern for 1994 2.2 GM Sonoma?

will the 2.2 crossmember on a 1994 GMC sonoma fit on a 1994 GMC sonoma 3.4

How do you change the Cabin Air Filter on a 2002 GMC Sonoma?

Are you sure your vehicle has one?

How do you flush the radiator on a 1994 GMC Sonoma pickup?

How do you flush the raditor on a 1992 GMC Sonoma Pickup.

Where is the crank position sensor located on a 1997 gmc sonoma 2.2?

were is csp on gmc sonoma 2.2

What is normal oil pressure specifications for a 2003 GMC Sonoma?

03 GMC Sonoma with the 4.3L Engine: @ 1000 RPM - Minimum of 6 PSI @ 2000 RPM - Minimum of 18 PSI @ 4000 RPM - Minimum of 24 PSI 03 GMC Sonoma with the 2.2L Engine: Minimum of 56 PSI @ 3000 RPM

How do you replace turn signal switch on 2003 gmc sonoma?

In order to remove the turn signal from your 2003 GMC Sonoma, you would need to remove the lower dash cover and also the steering column cover. I have included a video below in the related links section that will show you exactly how to fix this.

What are the torque specs for a 2.2L GMC Sonoma cylinder head?

what are the torque specs for a head on a 2.2 liter gmc sonoma

Where is the air temperature sensor located on a 2003 gmc sonoma?

The 2003 GMC ambient air temperature sensor is located on the bottom of the drivers side mirror. If you look up at the bottom of the mirror you will see the sensor.