The frequency of 50 Hertz (or 60 Hertz in other countries) was selected to reduce inductive power losses caused by long distance power line transmission and still enable alternating current to be converted to various voltages and currents using moderate sized Transformers at the point of power use.
The higher the power frequency the higher the inductive losses over a length of power transmission line.
For this reason frequencies higher than 60 Hertz are avoided.
Where possible electrical power transmission over long distances these days is accomplished with high voltage direct current, which is converted to alternating current near the usage areas.
50
A lot of points are factored when a utility decides to choose 50 or 60 hz, compare with america the machinces are constructed with 60 hz frequency and another reason is america is ecnomically better than the india so when freqency is high the power transmisson is at high rate and loosses also high.when they are economically good so for redusing the looses they are using good insulaters.
Well obviously India has a high population density of about 50 people a metre square
No, that's just a myth. It will work if plugged in correctly. Always check the voltage of a foreign device before plugging it in. Mayny electronic devices nowadays use switching powersupplies with wide input voltage ranges. As it is cheaper to design one supply capable of handling 100-240VAC on the input as opposed to one for each country's individual supply, they do that instead. On the power block or on the back of the unit there will be a sticker or molding that says the input voltage range. If it says 220V only, it cannot be used directly in the US, special steps are needed. If it says 120V, or a range encompasing 120V, it will work. Also note the line frequency. Again, most devices don't care (The first thing a switcher does is rectify it to DC), but if it doesn't say 60hz it will not work correctly. You have to use a converter. Because Japanese things have a different voltage level than America. Japan uses 100V, which is 60 hertz in western Japan and 50 hertz in eastern Japan. Radio Shack sells the converter you need.
1) The British colonized India. 2) India was under British rule for over 50 years. 3)The influence of Western ideas apex: the influence of western ideas or brought Christianity to Asia
50Hz
50 cycle per sec
Frequency is determined by the supply voltage, not by the load. However, for reactive loads (inductors or capacitors), the reactance will vary according to the frequency applied.
It's "hertz", not "hetz". The number of hertz is the frequency. For example, if the current has a frequency of 50 hertz... well, that's the frequency. Hertz is equivalent to cycles/second, and it is sometimes written that way. So, 50 hertz could also be written as 50 cycles/second.
50 hertz
In North America, it is 60 Hertz, and in Europe it is 50 hertz.
50 Hz as per the info available from their official website
In most parts of the world this is 50 Hz, although in the Americas it is typically 60 Hz. Current usage by country or region is given in the list of mains power around the world at: http://en.wikipedia.org/wiki/Utility_frequency
Wavelength= 10 mm. Frequency= 5.0 hertz. Speed= 50 mm/second (wavelength x frequency)
Yes, 240 volts is generated at 50 Hertz. This is a European frequency where as the frequency generated in North America is 60 Hertz.
Frequency = 1/0.02 = 50 cycles per second or 50 Hertz
50 hertz.