http://www.zedder.com/Info/78%20KE100-A7.htm has lot of spec details on different models and years.
This was my first bike - my dad bought it new for me and I always used Castrol 2-stroke injection oil. Any bike store will carry this.
The recommended oil capacity for the front forks of a Kawasaki KE100 is 160-170cc per fork leg. It is important to refer to the owner's manual for the specific type and amount of fork oil required for optimal performance.
Use a quality 2 cycle oil only. I recommend you use a synthetic 2 stroke oil.
yes for a 2 stroke engine.
Yes it can, but only in pre-mix 2 cycle engines. These are the ones that you add the oil to the fuel. If the engine is an oil injection model, there is an opti2 Injection oil available.
2 cyc. oil is used in all 2cyc motors.
Check your gearbox level you have an oil leak in your oil injection system or your gear box. The injection oil is lighter than the the gear box.
20w50
diagram oil injection system xlt 1200
IOR: is any method of producing or injecting (developing) a well (reservoir) that is not on primary production or commingled (not selective) production such as (secondary recovery like water flooding and tertiary like gas injection, chemical injection or microbial injection. EOR: its tertiary recovery techniques for increasing the amount of crude oil that can be extracted from an oil field either by using Gas injection, Chemical injection, Microbial injection or Thermal methods.
Use of a synthetic oil for the Suzuki DT50 outboard engine oil injection tank is recommended. A high quality 2T oil will provide maximum protection.
If operating the engine without the oil injection system, supplied with the engine, use a 50:1 ratio. When using the oil injection system, no additional oil is required.
generally if it has a separate resvoir you wont need to mix it just simplyuse good grade of 2 cycle oil