Usually copestone is used to form the sloping to course of a masonry wall. However if the client wants another type of stone, depending on how strong the wall has to be, there may be other possibilities.
What do you mean by 'masonry beariing wall'. A wall can be made of masonry. The part of a building which is weight bearing, is the foundation. What do you mean by thick Iowl der. Masonry walls are usually 10 cm thick, because this was thought to be a very practical thickness if building brick walls about 2&1/2 Metre high. Any thinner, and it would be unstable and fall down. Foundations are made about 45 cm thick so as to distribute the load of the masonry wall evenly over a large area. This reduces the worry that the wall may sink or drop, and allow the walls to collapse .
it is a wrie fixed on the both end of the wall.
A "rough opening" is the term for the opening in a wall into which a door or window will be fitted. It is slightly larger than the outside of the frame of the door or window to give some tolerance (space) to install it and get it in the exact position and square. It is measured between the structure to which the door or window will be fixed, such as the studs or masonry. The amount of tolerance between the frame and the structure varies depending on the type of construction and how accurately it is built, but is often in the order of 10mm all around the frame. An air seal and expanding foam are sometimes installed into this gap , and linings or architraves, and claddings cover it.
Brick masonryStone masonryAshlar masonryRandom rubble masonry
Its the same thing, its comes through a wall, same difference, install in a window, or install through the wall.
it's probably a block wall and it's solid concrete above the window and door openings try a masonry bit in your drill
If the wall is subjected to shear forces due to horizontal loading, it becomes a shear wall whether it is a masonry or a concrete wall.
With a little skill and knowledge you cut a hole through an out-side wall.
A drill with a masonry bit, some anchors and a wrench to tighten the anchors.
yes but it depends to the area that you installed window type air condition
I need this answer as well. Anyone?
Paint or Stucco
seriously? you cut a hole in the wall.Try not to hit any pipes or wires.
Usually copestone is used to form the sloping to course of a masonry wall. However if the client wants another type of stone, depending on how strong the wall has to be, there may be other possibilities.
What types of movement joints are required in a concrete masonry wall
Copestones