0
no it has a 3/8 dovetail rail
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Is a glenfield scope 4x32 stock on a marlin 39a?
The typical Marlin 39A does not have a scope. They are drilled and tapped that one can be added.
Can you put a raised scope on your 30-30 marlin model 336?
Yes.Most marlin model 336 rifles have been drilled and tapped for a scope mount on top of the reciever.
How do you put a scope on a savage 24e-dl it is not drilled and tapped for a mount?
You will have to have a trained and competant gunsmith drill and tap your receiver for a set of rings and bases to mount a scope on your savage.
Was the Winchester model 75 sporter ever drilled and tapped from the factory?
yes for a target scope .
Can you put a scope on a 270 bolt action rifle?
if it did not come with the provision to mount a scope on it you can take it to a gunsmith and have it drilled and tapped for one.
What size is a Remington 760 drilled and tapped for scope mounts?
Check the scope mount makers web sites or call Remington.
How can you mount a scope on a Winchester model 1300 defender pump shotgun?
Have it drilled and tapped by a good gunsmith.
Are scope bases interchangable with model 36 and 336?
the model 36 marlin was not drilled and tapped for scopes as it left the factory.I know because I have two of them.Your rifle may have been done by a previous owner as it was common to have a scope on a rifle during the last 50 yrs. You may by a model 336 base,be it 2 piece or one and see if the holes line up or have a qualified gunsmith inspect it and have him match up the mounting holes to a scope base.
How can you mount a scope on a Stevens Savage 12 gauge pump model 520?
The receiver will need to be drilled and tapped for a mount. See a gunsmith.
What is the proper scope base for a Ranger 22LR with heavy target barrel?
I seem to recall that may be the same gun as a Stevens 416. Most of those guns did not have drilled and tapped recievers. They did have drilled and tapped barrels for old style target scopes. You will probably do better to take it to a competent gunsmith and have him drill and tap it to fit a currently available scope base.
What scope and mounts can be purchased for a 22 caliber Glenfield Model 75 bolt action that has not been drilled or tapped?
These guns were never drilled/tapped for scope mounts. Like most inexpensive .22 rifles, the top of the receiver is grooved for tip-off mounts. The mounts and rings are typically one piece, and sold virtually everywhere - even WalMart.
Does an Inter Arms 30-06 mark x have predrilled holes in the barrel for a scope?
There are several different models of the Mark X, however, most have a RECEIVER that is drilled and tapped for a scope- not the barrel.
