A truck is normally driven from the front.
depends upon the truck, diffrent ratio's were used
Under the front of the truck on the diff. or hog head,This is where the actuator is located it has two wires on it and screws into the diff. or hog head,You will need to unplug the wire connector and then unscrew the actuator and replace it.
No.
the front diff is part of the gearbox and the diff/gearbox oil is the same-there is a dipstick on the offside of the box near the bellhousing.
when the truck has been driven 20 to 30 miles you can hear a noise comming from left front
It would be belt driven up in front of the engine.
You would find it in the front of the engine driven by the accessory belt.
The drive axels can be removed & replaced individually. If you've actually broken the front differential housing you will need to get the gear ratio and find out what kind of diff you have in the truck and make a trip to the wrecking yard and get a used one and replace the diff. as a complete unit.
Dana 44 front diff and 9.25 rear diff
no they are to big
As looking at the front of the truck, on the right side of the motor above the power steering pump. Driven off the belt.
Yes , Maruti 800 is front axle driven car..