27314. (a) No dealer shall sell or offer for sale any used passenger vehicle that was manufactured on or after January 1, 1962, other than a motorcycle, unless it is equipped with at least two seatbelts which are installed for the use of persons in the front seat of the vehicle.
(b) No dealer shall sell or offer for sale any used passenger vehicle manufactured on or after January 1, 1968, other than a motorcycle, unless it is equipped with seatbelts for each seating position.
(c) Seatbelts required in subdivisions (a) and (b) shall comply with regulations established by the department.
(d) The requirements of this section shall not apply to sales to dealers, automobile dismantlers, or junk dealers.
no it is legal in some states it is not illegal in Arizona , New York , or California
One reason the seat belt on your PT Cruiser is stuck is that there is a twist in the belt. The mechanism that retracts the seat belt may be jammed or broken.
it is broken
Check under the seat and see if the wires are unhooked or broken.
No seat belt.
Yes it is illegal, if you are not wearing a seat belt.
Check the wiring to the seat belt anchors. I would suspect you will find a wire loose, broken, or unhooked.
So you don't die if you crash. Plus it is illegal not to have them.
Seat belts are legally required in most jurisdictions. Wear your seat belt.
I have a Mazda Cronos 1994,the drivers seat belt has broken - the one on the right,small one.Where can I buy another one.
California seat belt law is described in section 27315 of the Vehicle Code. It says the driver and all passengers are required to be secured by a safety belt. Not being in a seat belt carries a fine of $25 for adults and $100 for children.
To replace a broken front seat belt on a BMW 328i, first, remove the lower trim panel and the bolt securing the seat belt retractor. Disconnect the seat belt from the buckle and retractor, then install the new seat belt by securing the retractor and buckle in their respective positions. Finally, reattach the trim panel, ensuring everything is properly aligned and secured before testing the seat belt for functionality. Always consult a repair manual for specific torque specifications and safety precautions.