yes but would not recmend the belt is pricy and hard to find if your compressor is bad thay do have bypass poleys to but it is also pricy if you need to get some string take the old belt off and go over the poleys with the string bypassing the compressor to get your belt size and go to the auto parts store to get the new belt and put it back on in the same patern as the old one skiping the compressor good luck
wher is the TPS located on a 96 oldsmobile ciera 3.1L ?
How do you tighten the serpentine belt on an oldsmobile ciera
The fuel pump for a 96 ciera is in the tank.
get a clue...
If the horn does not work on a 1996 Oldsmobile Ciera, you can replace the horn. Almost any type of horn should be compatible.
The low pressure port on a 1996 Oldsmobile Cutlass is between the compressor and the firewall. It is on the larger hose attached to the compressor.
I haven't seen a truck release for my 96 Ciera. I think you will have to go by the key itself.
on the driverside engine firewall
IT IS IN THE GLOVE BOX INSIDE CAR
It should Be located on the top of the transmission.
The firing order for a 1996 Oldsmobile Ciera is 1, 2, 3, 4, 5, 6. The pair of cylinders closest to the grill are 1 and 2, then come 3 and 4, and 5 and 6 are closest to the passenger area.
underneath the car behind the rear driverside tire.
where is the crank sensor located at on a 1996 cutlass ciera wit a 3.1 engine
follow the top radiator hose where it goes back to the egine
bum willy bum
The Oldsmobile Cutlass Ciera a was front wheel drive model. It was sold by General Motors from 1982 to 1996.
how replace vertical window guide channel
After repairing the cause you can reset with a scan tool or by unhooking the battery.
[http://www.partsamerica.com/product_images/img/acd/a905c.jpg 1996 OLDSMOBILE CIERA SL L4 2.2 Liter FI] [http://www.partsamerica.com/product_images/img/acd/a925c.jpg 1996 OLDSMOBILE CIERA SL V6 3.1 Liter FI] Good Luck and Remember.Change Your Mind, Not Your Oil.Use the First In Synthetic Motor Oil's.See My Bio For more information.
That is a typical thing on most cars, let it cool down some then try again
i have a 95, and i had to just remove the bottom radiator hose to drain and flush.
The easiest method would probably be to remove the fuse, if it's a dedicated circuit.