The ignition is live or hot and has power available. The term neutral does not really apply.
It will not hurt anything to leave the key stuck in the ignition on ACC in a Mazda van for short periods of time. The ACC slot on the ignition allows the driver to use accessories such as the air conditioner and radio without the car being in motion. If the key is left in this position for too long it can run down the battery in the car.
No it doesn't. The acc wire on your stereo is for accessory from your ignition switch. That's so you can turn your car key back and run your stereo without turning on the engine.
power for amp IT GIVE YOU A POWER SOURCE WICH IS SUPPOSED TO BE HOOKED UP TO THE ACC (ACCESSORY) WIRE FROM YOUR CAR WHICH WILL GO ON AND OFF WITH THE IGNITION. THIS IS NOT A CONSTANT POWER SOURCE, DO NOT HOOK YOUR STATION MEMORY OR CLOCK TO THIS POWER SOURCE
If the ignition is left in the on position, yes.
Your neutral safety switch-try putting car in neutral and trying it
The engine would shut down, but the rest of the vehicle would act as if the ignitoin was in the acc on position.
The key to my ignition broke off in the ignition. Luckily, I was able to insert the remainder of the key in the ignition and turn on my car. In order to fix the problem, I had to take my car to the dealer and I am pretty sure they removed it and installed a new ignition "key hole" keyed to my car. It is a 1990, and I believe the problem happened approx 1993?
Perform the following steps in order. 1. Turn on ignition without starting and wait 7 secs then turn to acc position and wait 4 secs. 2. Turn on ignition without starting and wait 7 secs then turn to acc position and wait 4 secs. 3. Turn on ignition without starting and wait 7 secs then turn to acc position and wait 4 secs. 4.Turn on ignition without starting and wait 7 secs then turn to acc position and wait 3 secs. 5. Turn on ignition without starting and wait 7 secs then turn to acc position and wait 2 secs. 6. Start car and wait 3 secs then turn off wait 3 secs and start car. Took me 2 tries as I was not getting the timing right...but it worked.
1) Get into car 2) Put keys in ignition 3) Turn to "on" position 4) Apply Brake 5) Shift into neutral 6) Start the car
Starter, battery, battery connections, neutral switch,
If you have an automatic transmission, make sure your car is in park. If you have a manual transmission, make sure its in neutral. Other than that you may need a new ignition switch.
It sends the proper signal to the ecu to allow certain curcuits to close to allow power to the acc, on and run positions with the key.