Chevy Blazer S-10

Is there a starter relay for a 1994 Chevy S-10 Blazer?

212223

Top Answer
User Avatar
Wiki User
Answered
2005-10-23 02:42:39
2005-10-23 02:42:39

No, there is a starter solenoid located on the starter motor.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The starter relay on a 1994 Chevy Silverado is mounted on the starter. The starter and relay are usually changed as a single unit.

The solonoid is attached to the starter. VBdenny

Which relay is the starter relay on a 1994 buick lesabre

on the passenger side of the vehicle right under the exhaust manifold

The relay is on the starter and the starter is on the engine front right under the exhaust pipe.

how to drai torque converter on 1999 chevy blazer

The starter for a 1994 Chevy Cavalier is on the side of the engine at the rear. Always disconnect the battery before attempting to remove the starter.

Where is the tcm in a 1994 chevy S10 Blazer

How do you install a 1994 Chevy blazer electric window? In:http://wiki.answers.com/Q/FAQ/603[Edit categories]

There's no starter relay on the 1992 nisssan sentra, but there is a ignition relay which controls the starter and this should be located somewhere in the engine compartment where the relay box is

Swap the relay with another like relay.

how many oxygen cencors does the 1994 Chevy blazer have

+ battery cable should be connected to relay

Starter solenoid is a part of the starter itself, the ignition relay can be found in the main electrical control panel under the hood.

The 1994 Chevy Corsica fan relay switch is located beneath the passenger side dashboard. The fan relay switch should be labeled as such.

It is mounted on the top of the starter.

The fuel tank on a 1994 full size K15 blazer is 30 gallons.

On the top of the starter where wires connect

drivers side, below the dash, just look from the pedals upside-left. There is a plastic housing with some fuses and some relays

The starter solenoid is mounted directly on the starter.

Unbolt the the power wires after disconnecting the battery. Then pull out the 2 or three bolts holding it in. then pull out the starter. Reverse for installation.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.