0
Is there a tool to remove the trans-axel on the passagers side?
Wiki User
∙ 11y ago
If you mean the CV shaft itself, no, there are no special tools required, normally.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you change clutch Toyota Tercel?
It's not a real hard job but it takes time. I did it in about 5 hours. - Remove battery - remove wheels and wheel assemblies - remove air filter and intake assemblies - remove backup light switch connector - remove and mark shifter assemblies - remove speedometer cable - remove 24mm plug from transaxel housing and drain fluid - remove plastic splash guards from font of body-10mm and 12mm wrenches - remove 30mm axel nuts from both sides - remove fron ball joint control arm bolts -14mm wrench - tap transaxels out - pull transaxels out from transmission - remoive starter cables -12mm wrench - remove 3 bolts on thin flywheel cover under car-10mm and 14 mm wrenches - remove transaxel bracket - 3 17mm bolts - remove lower transaxel -to-engine mount - 14 mm wrench go back up top and remove the 12mm bols holding the hydraulic slave cylinder on the front of the transaxel housing - losen only!!!! the upper transaxel-to-engine mount - remove the lower transaxel-to-engine mount - 17mm and 14mm bolts - position a jack under the engine oil pan to support engine - position a floor jack with wheels under transaxel housing - remove all bolt securing the transaxel housing - separate transaxel housing from engine and lower it - remove clutch cover - 12mm bolts - remove clutch - using a centering tool, install new clutch - re-install clutch cover - torque to 15 ft/lbs now, put it all back together. I found that the best way to re-attach the tyransaxel housing to the engine was to ust an engine hoist on wheels as I was doing this operation solo. If I'd had help, a motorcycle jack would have done quite nicely or a floorjack on wheels if I'd had two helpers Have fun..every real man must do at least one clutch replacement in his life.
Where is the fuel filter on a 1997-98 Chevy Corvette C5?
DRIVER REAR, NEXT TO DIFFERENTIAL UP AT THE TOP MOUNTED TO THE SIDE OF THE BODY. YOU DO NEED A SPECIAL TOOL TO REMOVE IT. IT IS VERY EASY TO REMOVE WITH THE TOOL.
How do you remove a side mirror from a 2001 Fiat Punto?
take window adjuster case of...remove the nut, is there a special tool to remove the mirror unit. There is a thread on the new mirror which goes into the door
What tool is used to remove a stripped side post battery terminal?
A simple pair of locking pliers (vice-grips)
How do you remove radio in Daewoo kalos?
The trim on either side of the radio needs to be removed This is best done with a trim removal tool Once the trim is off you will see two bolts each side of the radio Remove these and the unit is out
How do you remove timing gear on 94 dodge 2.5?
There is a special tool ( a puller ) to remove the crankshaft sprocket.There is a special tool ( a puller ) to remove the crankshaft sprocket.
What tool to remove a front brake pads on a 2007?
= What tool to remove a front brake pads on a 2007? =
How do you remove the drive side window crank in your 90 Pontiac transport?
May have a horseshoe type clip on the concealed back side Tool available at auto parts store -not expensive
Do you have to remove the dash for a 1986 Ford Ranger to get at the factory stero and how would you remove it?
No you don't have to remove the dash, there are four little holes on the face of the factory stereo which require a removal tool this tool can be purchased at the Ford dealer for a resonable price, after you insert the tools (one on each side) than you will be able to pull the stereo out.
How do you remove the door lock Knob on a 1966 corvette?
you must push in on the door panel at the knob. There is a u-shape wire clip that is on the back side of the knob. There is a tool that cost about 5.00 that will unsnap the clip or you can make a hook shape tool from stiff wire to remove the clip.
How do you remove a power steering pump on 1990 Chevy Cheyenne 4.3?
open hood insert tool use tool remove pulley remove bolts remove pump
How do you change out a 94 Lincoln mark 8 fuel filter?
I think that it's the same as my 95. The filter is on the passenger side behind the plastic shroud (wheel weld) on the left side. You have to remove the tire and the shroud to get to the filter. You will also need a filter remove tool which inserts under the filter to release the line. You can buy this tool at any auto parts store.
