To be a Series circiut the electricity MUST flow THROUGH one load to the next.
"added"
They have the same current.
A circuit in which loads are connected side by side is known as a parallel circuit.
Loads are connected side
That is described as a circuit in series, as opposed to a circuit in parallel, in which there is more than one loop.
a series circuit
In North America the neutral wire is never fused. This is because of the three wire circuit that uses a common neutral. If there are two loads connected across a common neutral circuit and the neutral opens a 230 volt supply will be impressed across both loads as they are now in series with the supply. If both loads were balanced then the voltage drop across both loads would be equal. Dropping 120 volts across each load. Where the problem arises is if the two loads are not balanced and voltage drop goes higher than the manufactures recommended voltage, then the connected device could burn out.
series circuit
A circuit in which loads are connected side by side is known as a parallel circuit.
Loads are connected side
Your question is very muddled and it is difficult to understand exactly what you are asking. Something is in "series" if it is connected in the circuit as a "daisy chain". Thus both loads AND batteries may be placed in series.
That is described as a circuit in series, as opposed to a circuit in parallel, in which there is more than one loop.
A circuit in which elements are connected in series.For example in RLC series circuit resistor,inductor and capacitor are connected in series.
When you have multiple loads in a series, the resistance of the loads is added together allowing very little current to flow through the circuit to power any of the loads, making for a low amperage circuit. If you have your loads in parellel, the resistance of the loads in the circuit is subtracted which allows more current to flow, making for a high amperage circuit.
It is a series circuit with all the components connected in series.
Parallel to each other.
An ammeter is always connected in series in the circuit.
When you have multiple loads in a series, the resistance of the loads is added together allowing very little current to flow through the circuit to power any of the loads, making for a low amperage circuit. If you have your loads in parellel, the resistance of the loads in the circuit is subtracted which allows more current to flow, making for a high amperage circuit.
Voltmeters are connected to simple series circuits the same way they are connected to any circuit. They are connected in parallel with the portion of the circuit for which you wish to measure the voltage drop.