The PCM, or EEC, would likely be under the dash on the left of the ashtray. At least that's how it is on my '90 F250.
the computer is behind the glove box 88-95
where is the fuel transfer pump located
Do you mean PCM ? Its in the engine compartment drivers side by the relays and battery
Directions on how to replace a fuel pump on a 1995 F250 diesel 7.3
1996 ford thunderbird pcm power relay location?
In the power distribution box, in the engine compartment of a 1997 Explorer, (PD BOX IS LIVE - DISCONNECT YOUR BATTERY CABLES ) in location # 2 there is a 30 amp maxi-fuse for the PCM power relay in location # 11 there is a 20 amp maxi-fuse for the PCM MEMORY and horn Relay# 5 is the PCM POWER RELAY and diode # 2 is the PCM DIODE ----------------------------------------------------------------------------------------------------------- In your fuse panel - visible with the driver's door open location # 13 - 15 amp fuse - for PCM system/stoplamps/AWD/ABS/speed control/ trailer tow location # 19 - 25 amp fuse - for PCM system/ ignition coil
On a 1997 Ford Ranger : The PCM location should be the same as on my 1995 Ford EXPLORER ( if you look in the engine compartment at the firewall you should see where the wiring harness is bolted to one end of the PCM , it is towards the passenger side of the vehicle , and most of the PCM is " hidden " behind the glove compartment )
PCM is located in bottom of air box
no.. you can run the mustang pcm in the tbird but you have to repin the harness
The pcm is located on the drivers side of car, by the radiator.
The PCM has detected a fault and set a trouble code.
The PCM is bolted through the fire wall. Behind the parking brake. You will need to remove the driver side inner fender liner to get at it.