The MAP sensor is located on the passenger's side strut tower. There is a solenoid connected to it by a short piece of hose, and a hose runs from that solenoid to the intake. The MAP sensor will have a 3-pin electrical connector on it.
on a 1992 Camry the map sensor is attached to the center of the firewall by a bracket and has a rubber vacuum hose connected to it.
ck for vacuum at map sensor hose, if it is vacuum present replace the map sensor.
No
Early 4.0's the MAP is located directly behind the valve cover on the fire wall, it has a vacuum hose that connects to the throttle body and is connected electrically to the computer.
The MAP Sensor is on the back side of the engine, toward the top-middle. There should be a bracket w/ a hose coming out of the center. The MAP Sensor should be just to the left of the hose (Passenger Side).
Map sensor is located on the hose going from the filter box to the throttle body. There is only one sensor in that area.
MAP Sensor on a 1994 Cougar is located on the firewall. Has a vacuum hose coming from it and an electrical connection.
a square with a nipple for a vaccuum hose, usually bolted to the firewall
Air Leak or hose has come off from MAP sensor
Just below the hose attached to the throttle body
Yes, it is the small senor about the size of a car alarm remote with a four pin connector and a single vaccum hose connected to it. It is located on the firewall just to the right of the intake.