0
Should be dot 4
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Can you use car brake fluid in a motorcycle?
Yes you can but it must have the same DOT
How much does a motorcycle weight?
There is no specific weight regarding Motorcycles. There are two types of Motorcycle weight.The dry weight of a motorcycle excludes some or all of the following: gasoline (or other fuel), engine oil, coolant, brake fluid, or battery.The wet weight of a motorcycle includes, but is not limited to fuel, engine oil, coolant, brake fluid, and battery.
Will brake fluid leaking on motorcycle tires be harmful to the tires?
Brake fluid will make the surface of the tire slick, resulting in loss of traction. If left un attended for a long period of time, the brake fluid will "dry rot" the rubber and cause separation.
Where to pour brake fluid on motorcycle?
usually in small resivoir top of handlebars. On the right hand side and the clutch usually takes brake fluid too if they are hydraulic on the left hand side.
Where do you put clutch fluid in a 1995 ford escort?
It uses brake fluid in the brake fluid reservoir. The clutch fluid (brake fluid) is fed by the brake fluid reservoir. The clutch fluid reservoir is just beneath the brake fluid reservoir. So, add fluid to the brake fluid reservoir to fill the clutch fluid, also.
Can you mix synthetic brake fluid with normal brake fluid?
Yes. Normal brake fluid is actually synthetic
What kind of brake fluid for 2002 grand am?
It is important to maintain the brake fluid levels in a car. The brake fluid type for a 2002 Grand AM is DOT 3 brake fluid.
Can Castro oil be used for brake fluid?
Only brake fluid can be used for brake fluid. Brake fluid is a glycol-based liquid - it's closer to antifreeze than to oil, but don't use antifreeze in it either. Only brake fluid.
Does a 1989 jeep cj7 take brake fluid and transmission fluid or just transmission fluid?
The brake system uses brake fluid and the trans uses trans fluid.
How do you add brake fluid on forklift?
Locate the brake fluid reservoir, and pour brake fluid in until it's at the appropriate level.
Is j-b weld resistant to brake fluid?
yes if allowe to dry 24 hrs but should NOT be used on lines or tubeing or any pressure point ... if youre fixing the resivour it should be fine if the parts repairing are reaaallllyyy CLEAN No J-B Weld is not fully resistant to brake fluid. I used it on a brake resivour for a motorcycle. It held up for a few years, but over time J-B Weld was broken down by the brake fluid.
Where do you add Brake Fluid?
Good question. At the brake fluid resovoir
