http://www.bodyshopzone.com/archives/trim/door_panels/Oldsmobile/Cutlass_93/remove_dp_Cutlass.html
On the back of the radiator, driver side.
There were a reported 3,912 Cutlass convertibles sold in 1992
It has an electronic shifter at the driver side end of the trans. the vaccum days are over.
The Explorer was introduced in 1991. In the 1991 and 1992 Explorers the fuse panel is underneath the dashboard between the steering column and the driver's door.
To remove the driver side door panel on a 1992 300E all the mounting screw must be taken off. With the screw off, the remaining clips which hold the door panel need to be gently pried off. After all the hardware is removed the panel can be pulled off the door.
To remove the door panel on a 1992 Cadillac Eldorado for the driver's side window, start by disconnecting the battery for safety. Carefully pry off any trim pieces and remove screws located in the armrest and around the panel edges. Use a flathead screwdriver or a panel removal tool to gently lift the panel away from the door frame, being cautious of any clips or wiring. Finally, disconnect any electrical connectors before fully removing the panel.
Lower dash, driver's side. Behind a panel. LOOK!
Answer Whenever I replaced my mom's sterio in her '95 it was located behind the panel in the cargo area. It was located behind the passenger side panel. I imagine it is in the same place in the '92 since they were similar models. You have to use a clip removal tool or some sort of flat screw driver to remove the clips on the trim panel and the large panel it is behind. Hope this helps you. Good luck.
The Kelley Blue book on a 1992 Oldsmobile Cutlass Ciera ranges from $1825 - $2175.
The 1992 Mercedes-Benz inside door panel is held in place by two retaining bolts and 12 retaining clips. Remove the retaining bolts and pry outward on each retaining clip.
under driver side main fuse panel there are 3
Its on the door panel next to the door handle. at least that's where it is on my 1992 190e 2.3