Open the trunk. You'll need to pull the black plugs out that hold the carpet to the wall of the trunk. Once you pull the carpet back, you'll see 3 or 4 nuts that you will need to remove with a wrench or small socket. After these are removed, the light will pull out. Just twist to remove the burned out light. Reverse process to replace.
I need timing mark for Toyota paseo
replace the break light switch located under the dash on the brake pedal arm. It has a clip on the side the pulls out and then a pin that comes out.
My only knowledge is that the tercel may have exchangeable parts with the Paseo.
In a 1992 Toyota Paseo, the stop light switch is typically located near the brake pedal assembly. It's mounted on the brake pedal bracket and is activated when the brake pedal is pressed. To access it, you may need to remove some panels or covers under the dashboard. Be sure to check the vehicle’s service manual for specific details and diagrams.
Please check that the brake light bulbs are installed correctly and that they are not back feeding the side lights
If the spoiler is factory installed with a LED 3rd brake light, it will be a dealer item only. You might find a used one in a junk yard, but good luck.
Toyota Paseo was created in 1991.
it is an extra option you can get from the dealer when you buy the car.
where is the flasher located on a 1992 toyota paseo
a 1997 Toyota paseo i forget to tell...H4?
To replace a dash light on a 1996 Toyota Paseo, first, disconnect the negative battery terminal to ensure safety. Remove the dashboard trim by unscrewing any fasteners and gently prying it off. Once the dashboard is exposed, locate the burned-out bulb in the instrument cluster, twist it counterclockwise to remove it, and replace it with a new bulb. Reassemble the dashboard and reconnect the battery.
Forget to take out the key