Take the door panel off. The old switch or switch cluster should pop out of the panel when you release it from the tabs. The new switch which you ordered will plug into the window switch wiring harness. This will only plug one way; therefore, you can't go wrong. Pop the switch or switch cluster back into the door panel; attach the door panel back to the door frame.
Wiki User
∙ 2008-01-08 05:14:49If there is any of the window up and you can grab it you can pull it up and then with both hands, one on each side, push the window up. If it is completely down you can't do it. How about removing the power window switch and either replacing it or wire around it long enough to get the window up.
You probably have a bad window master switch
The power window motor could be bad.
I tried replacing the window switch , this isnt the problem all windows still wont work.
A power window relay switch relays the power from the car's battery, to the switch itself, and then to the window motor. When pressing the button inside of the car it allows the power to go from the relay switch to the motor and roll the window up or down.
usually by replacing window regulator.
If you mean the extra switch on the drivers side power window control it cuts power to the passenger side window switch. Handy if you have kids.
You can try replacing the master control switch on the driver's door. If that doesn't fix it you will need a new window motor.
the switch is on the door panel approx four inches from the window, this is the only switch that sends power to the window regulator motor (window motor).
Defective passenger power window switch. It is stuck in the down position. Raise the window and immediately disconnect the switch until you can replace it.Defective passenger power window switch. It is stuck in the down position. Raise the window and immediately disconnect the switch until you can replace it.
If it looks the same it will probably work.
Replacing 2002 Dodge power window motor driver side