Disconnect the negative battery cable for about two minutes and that should reset your check engine light.
you have to hook up a scaner and press code reset or a auto zone store will do it for you
There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.
With a scan tool after repair.With a scan tool after repair.
There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.
The check engine light on a 2005 Jeep Grand Cherokee looks like this... Here is a link Check Engine Light It looks like a little yellow engine.
Check engine light is reset with a scan tool.Oil change due is reset by pressing "step" until "0 miles to service" is displayed. Then press and hold "reset" until it resets.
Disconnect the positive cable on the battery and reconnect it that should reset it. If there is a true problem it will come back on. or go to an advance or autozone and they will erase the code for you free.
Disconnect the positive cable on the battery and reconnect it that should reset it. If there is a true problem it will come back on. or go to an advance or autozone and they will erase the code for you free.
You will have to get the engine scanned and the necessary repairs made. Then the check engine light can be cleared. Just to clear the light without the repair will result in the light comming back "on."
With a scan too or with a battery disconnect.
A flashing check engine light normally means you have a misfire.
The check engine light is reset with a scan tool after repairing the failure. Unhooking the battery may turn it off temporarily, but it will return if not repaired.