Car Computers and Sensors
Dashboard Lights and Gauges
Toyota RAV4

Reset the maintenance required light on 08 Toyota rav 4?

001

Top Answer
User Avatar
Wiki User
Answered
2008-11-26 10:48:19
2008-11-26 10:48:19

maintenance with engine

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


How to Reset Maintenance Warning Light on a 2008 Toyota 4Runner

How do you reset the maintenance required light in the 2011Toyota RAV4 with a smart key starting system

Your drivers manual should give you the information to reset the oil maintenance light.

You will need to take it into a mechanic. They will be able to check out your vehicle and then they can turn off the light.

A maintenance light on a Toyota Camry can be reset by your mechanic after you have the work done that is needed. You also may be able to get instructions by checking your manual.

How do you reset maint read light on 2010 corolla

Resetting the maintenance light on a 1999 Toyota Tacoma is very easy to do. To reset the light, take the battery cables off for up to one minute to reset the light.

Check engine light or required maintenance light. Procedure for resetting required maintenance light just answered. Check engine light requires an OBD II to determine problem and turn the light off.

How do you reset maintenance reminder light on 2008 Toyota corolla? For what it is worth: To reset the Maintenance Required light on my 2007 Toyota Corolla: 1) Set your trip meter to the odometer setting (in other words, not Trip A or Trip B) 2) Hold down trip meter reset button and turn ignition to off. 3) While holding down the trip meter reset button now turn the ignition to on. 4) Keep holding down button until Maintenance Required light shuts off. Note: One some other Toyota models you hold down the Trip A meter rather than the odometer. Hope this works for you.

A person can reset the maintenance required light on a 2004 Toyota Sienna by holding down the odometer trip button. A series of zeroes will appear, which indicates that the light has been reset.

The maintenance light,You will need to take it to a Dodge dealer to reset it. Or get a DBR-2 code scanner.BIG $$$

same as a 2005 odometer OS on turn key off hold reset turn key on loght flashes then turn off

Are you implying they are all the same? BClear.

The maintenance required light requires a scan tool to be reset.

Go to Autozone or Advance They will reset it for free.

To reset the maintenance required warning light on a 1989 Dodge Dakota, unhook the battery connector cables for 10 minutes. Reconnect them and start the vehicle.

With the engine and ignition off push and hold in the odometer reset button. While holding that button in, turn on the ignition but do not start the engine. After about 5 seconds the light will go off and the maintenance required light will have been reset.

How do you reset the maintenance light on a 2001 Honda accord ex I found some options at http://www.tegger.com/hondafaq/maintenance-reqd-light.html#why

Turn key off. Push mileage reset button. Keep it pushed in while you turn ignition key to on position. Hold for 10 secs...

Set the odometer reading to total miles and not to trip miles. Now press and hold the odometer reset button in and turn the ignition switch to the on position. (Do not start the engine). After around 5 seconds of holding the reset button in the maintenance required light will go off and be reset. Release the button and turn the ignition off.

You need a special computer for that. Check the gas cap first, make sure its tight, sometimes that sets it off.

how to reset maintenance light on mercedes s550 amg


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.