HomeReset the stop light switch on a Mitsubishi montero sport?
Look at the upper end of the brake pedal under dash area
Related Questions
unhook the battery for about 10 min. should reset
The Montero Sport's tailgate dome light doubles as the switch. The entire clear plastic cover slides left to right and has three positions. ON-DOOR-OFF
A bad A/T Control Relay switch may be the reason your light is blinking on the N of the shift gear in your Mitsubishi Montero Sport. The part will need to be ordered from the dealership to fix it.
After repairing the cause of the code, you clear the code with a scan tool.
The parking brake light stay lit on the 1999 Mitsubishi Montero sport the parking brake is working and you have not put the light off.
The 1995 Mitsubishi flasher relay switch and the brake light relay switch can be found beneath the dashboard. Both switches will be on the drivers side of the dashboard, near the brake pedal.
After my 1995 Montero turned 150,000 miles the
how i reset check enging light manually at mitsubishi fuso 4m50
HeyKen==You need to repair what turned it on in the first place then have auto zone remove the trouble codes. GoodluckJoe
There isn't a switch to reset the light. You 'reset' the light by fixing the problem which is causing the light.
I replaced transmission fluid yesterday on2003 Montero Sport today when I'm driving the A/T Temp light came on what is that mean/
You can try to reset your brake light switch by unplugging the brake light switch and plugging it back in. If that does not solve your problem you will need to replace the brake light switch.
Why does four wheel drive light flash?
No reset switch on a Dodge Ram.
You have to take off the fender well.
your stop light switch may have gone bad. it is located on the brake pedal under dash board. if the tail lights turn on when you turn on your lights then the problem will most likely be the switch '''(easy to replace)'''
no reset switch in this system
Look on the door frame at the lower corner farthest from the door hinges. The switch faces out to the street and ususally has a small rubber bellows on it that may make it look like a bumper instead of a switch.
There isn't a reset switch. The light is reset with a scan tool after the cause of the trouble code has been repaired.
The oil light in a Jeep Liberty can be reset. To reset the light turn the ignition switch on or off without starting the engine. Next depress the acceleration pedal at least three times and then switch the ignition switch in a locked position.
A 2002 Jeep Wrangler does not have a reset switch.
disconnect the battery for a couple of minutes, if it comes back on after you drive the computer is getting an error code from the engine check the codes to see whats causing it
check the fuse box under the hood in the engine compartment
Is the " FUEL RESET " light in your dash on If the button has not popped up on the top of the inertia switch than the switch doe's not need to be reset
The PWR light isn't a warning light, it just indicates the car is set in power mode. This means it is shifting at higher RPMs than when not in power mode. There is a switch near the shifter lever that will allow you to change it back if you want.
Asked By Wiki User
How long does it take to cook a 23 pound turkey in an oven?
Asked By Wiki User
How long do you cook a turkey?
Asked By Wiki User
Reset the stop light switch on a Mitsubishi montero sport?
Asked By Wiki User
What is the conflict of the story of sinigang?
Asked By Wiki User
How will understanding of attitudes and predisposition enhance teaching?
Asked By Wiki User
What is the contribution of candido bartolome to gymnastics?
Asked By Wiki User
Who of the proclaimers was married to a little person?
Asked By Wiki User
Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.