answersLogoWhite

0


Best Answer

Treadles

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Rocking levers operated by the feet to drive a machine?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is threadling?

-> To work a Treadle. or-> a pedal or lever operated by the foot for circular drive,as in a potter's wheelor sewing machine.


South Australia's giant rocking horse?

There is a Giant Rocking Horse located at Gumeracha, a couple of hours drive out of Adelaide.


Is it hard to drive a tank?

sort of because there are a lot of levers and buttens


What is the difference between drive and machine?

what is the difference between drive and machine


Can you tell when the drive is about to fail?

The drive will start to make a sound that is audible different than normal. This is because the drive is being operated at a speed that is too fast and will fail soon.


How do winches on wreckers work?

They are geared drums that the cable winds around pulling what is attached. In the old days we used a direct drive drive shaft off a manual transmission to the winch gear box to drive the winch. It was possible to do a Lot of damage to the machine if it was operated incorrectly. More recently the winch is driven Hydraulically, either of the electrical system of the trucks but more commonly from an engine driven pump.


Compare group drive Vs individual drive?

1.In group drives initial setup cost is large where as in Individual drives it is comparatively low. 2. In group drive line shaft has to be driven even if single machine is required to run where as in individual any machine can be operated independently. 3. In group drive wider variations of speed can not b e obtained where as in individual drive variable speed transmission is possible. 4. In group drive efficiency is comparatively less than that in individual drive. 5.In group drive running cost is comparatively high. 6.In group drive cost per H.P is low comparatively. 7. In group drive ,in case of failure of main motor, entire workshop stops. 8. Power required is more in group drive.


How do you remove the drive shaft from washing machine?

pull it out


Why does 1996 Nissan Pathfinder 2 wheel drive sways in a rocking motion?

The front suspension housing and struts on a 1996 Pathfinder are severely corroded.


Can you drive in Assassins Creed 2?

yes you drive a carrige with lerernardo and you control a flying machine


Do you need a drivers license to drive a moped in Oklahoma?

If they are lawful to be operated on the public streets and roadways, yes.


What do they use cotton for?

they use a machine they drive it through the cotton