Headlights Tail and Brake Lights
Mercedes-Benz C-Class
Turn Signals and Hazard Lights

Signal lights not working?

192021

Top Answer
User Avatar
Wiki User
Answered
2009-05-04 13:34:31
2009-05-04 13:34:31

signal lights not working.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Either hand signal or check and replace your fuses and turn signal bulbs.

When the signal lights are not working on a car, there are a couple of things that could be going on. One could be that the bulb needs to be replaced. The other possibility is that the signal relay needs to be replaced.

It's the turn signal indicator-located behind the hazard lights.You have to take it out and replace it.

Trun signal lights do not come on at all not on dash or outside

Signal lights staying on withot flashing indicates either front or rear signal bulb not working on the Audi

Turn left indicator signal flashes rapidly when I use indicator, bulbs ok, no lights working

Probably the flasher unit needs to be replaced. This is an electronic switch which usually mounts underneath the dashboard.

WEllllllllll as long as you have working brake lights, headlights, and signal lights then yes, yes indeed.

do you hear clicking noise -as if the inficators were working? If not then go check the flasher relay and its connections.

How bout the turn signal indicator switch located in the steering column.

There are separate fuses for trailer signal lights in main fuse panel

I would check the running lights for one with a short. I had the same sort of thing with my trailer and I spent way to much time troubleshooting the brake and signal wires. Turns out a running light bulb connector was grounding out on the trailer and messing it all up.

Be sure to keep the rear tail lights, brake lights and signal lights in good working order. To many times you see vehicles with lights missing.

If the turn signal is working it's either the brake light switch or the turn signal switch.

I have a 93 deville,still have not found the turn signal flasher and the signal lights stopped working,but after checking if all the lights were working I found one small blub burnt out in the back set of lights,I removed it and signal lights started working again if anyone find the exact location please post,4 way flasher is easy to find ,signal flasher a problem On the 92 deville, the turn signal flasher is on the driver side (Left side) of the steering column. It is above the fuse block and is difficult to see. Move the wires and you will see that it is close to the hood release.

you should try checking the fuses and replacing the bulbs the fuses for thos lights should only be about a 10 or a 15

It needs checked out but both the hazard and brake lights go through the turn signal switch.

when my 1986 w-250 turn signal switch went out the brake lights quit working.

you need to change the flasher can for the signal lights


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.