answersLogoWhite

0


Best Answer
Subaru brake inspectionMost Japanese vehicle drums are not secured unlike American vehicles.Remove wheel there are 2 holes with threads on front of drum you have to put bolts in these and going back and forth tightening each one half turn at a time until drum is pulled.Often the bolts are already there but are holing the drum on you have to remeve them and put them in the threaded holes in hub
User Avatar

Wiki User

โˆ™ 2011-09-13 14:35:40
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: Subaru Legacy possible to inspect rear brake drum shoe wear on Legacy 2000?
Write your answer...
Submit
Related questions

Where can you find a diagram for the parking brake on a 2001 Subaru Outback?

In The Subaru Legacy(Outback) Service Manual and the Chilton or Haynes Repair Manual for the Legacy & Forester 2000 thru 2006.


Is it possible to inspect rear brake drum shoe wear if so how on a 2000 Subaru Legacy?

Well, its impossible to check the rear brake drum shoe for wear because..........they don't have them. Your car has disk brakes, not shoes. You should not work on your car if you have NO idea what your talking about. GOT IT! Take the car to a shop where even a 16 year old can help you!


How do you get a 1994 Subaru legacy wagon out of park?

push foot down on brake pedal, hold in button on gear shifter and pull down


How to change brake fluid on a Subaru legacy 1995?

Get a turkey baster to syphon brake fluid out of master cylinder resevoir Re-fill master cylinder with new brake fluid Bleed brakes Longest line to shortest


Subaru Outback brake caliber?

You are going to have to formulate a real question. Yes, Subaru Outbacks have brake calipers.


Will a bad proportioning valve prevent brake fluid from going to the caliper on the passenger wheel?

Yes, that is possible. I would also inspect for a collapsed/damaged brake hose or a pinched brake line on the passenger side.


Do I need a modulator for a trailer hitch on your 1993 Subaru Legacy in wagon in order for the trailer lights to work?

Yes. You need a converter to combine the turn signals with the brake lights.


1995 subaru legacy outback Why is brake-battery light on just replaced battery and alternator but brake-battery light still on goes off when car is idle but comes on when you press gas pedal?

Put some brake fluid in the master cylinder.


Why does the rear end of your 1999 Subaru Outback Legacy sound like its knocking?

i don't know if it helps, but my '99 legacy outback was making a knocking sound. turned out that the oring on the brake caliper pin had worn out, and the pin was kind of knocking around.


What are some causes of brake fluid leakage on a 2003 Kia Rio?

The best way to find out where the leak is coming from is to inspect/observe, if possible. As far as what parts could be the culprit, there's the brake master cylinder, a hydraulic brake hose, or a brake caliper.


Do you have to replace rotors each time you do a brake job?

first measure the brake rotor then inspect the rotor surface inspect the brake pad surface if either is rough or irregular then replace the rotor you will have better brake performance and brake pad -rotor life thank you


Why doesn't your 1996 Subaru Legacy automatic-transmission shift out of Park and have already tried depressing brake pedal and releasing the shift lock under shift plate?

Try your brake lights. There is a sensor under the brake pedal that will go off if you don't have any. This should be an easy fix.


What are the 60000 mile requirements for servicing a 2005 subaru legacy?

60,000 Mile Maintenance Item (I = inspect, R = replace, P = perform) Drive belt(s) [Except camshaft] R Camshaft Belt (timing belt) 2.5L I Engine oil/filter R Replace engine coolant, inspect system, hoses, connections P Replace fuel filter, inspect system, hoses, connections P Air cleaner R Spark Plugs 2.5L R Brake fluid R Brake pads, linings, front/rear axle boots, CV joints, axle half shaft, parking brake I Clutch and hill-holder system I Steering and suspension I Front/rear wheel bearing lubricant I Rotate tires P


Where is fuel filter on 2004 Subaru legacy?

The fuel filter is found inside of the fuel tank. It's hard to reach it. On earlier subarus, the fuel filter was found in front of the brake master cylinder.


Grinding noise from brakes at low speeds?

I would suspect your brake pads are worn out. The grinding you are hearing is the destruction of your rotors taking place. It is also possible that you may have a defective wheel bearing. Inspect your brake system.


Why does the left rear wheel on a 1990 Chevy 1500 keep locking up?

Brake problem. Remove the rear wheel & brake drum, and inspect the brake components. You may have a leaking wheel cylinder or other problem. Also inspect the wheel bearing.


How much is the cost of a disc brake repair?

When you are taking your brakes apart you want to be sure and inspect all aspects of the system as you are removing the parts and watch for possible wear and leaks.


What does service code B1 mean 2011 Acura MDX?

B =Replace engine oil and filterService front and rear brakesInspect parking brake adjustmentsInspect tie rod ends, steering gear box and bootsInspect suspension componentsInspect driveshaft bootsInspect brake hoses and lines (including ABS)Rotate tires , inspect for wear and adjust pressureCheck all fluid levels, condition of fluids and check for leaksInspect exhaust systemInspect fuel lines and connections1 =Tire rotation.


How do you replace a crankshaft sensor on a 1996 Legacy Subaru?

its right in the front middle of the engine/ unscrew the bolt and pull it strait up/ if it gets stuck in the hole you will have to use a drill and carefully poke holes in it and brake it apart then pull it out


Why do your light stay on on your 2005 Subaru Outback?

Brake lights? Check brake light switch for adjustment or replacement


Why would both tail lights on a 1998 Subaru Legacy not work and it not be a fuse?

first check your brake light switch... its located on the brake pedal one wire should power on it all the time and the other wire only when the pedal is pressed... if power doesn't go thur then replace switch


Why does your brake pedal go down and you feel a crunching sensation when you brake?

Pads are worn out, and your Mater Cylinder is possibly bad. Inspect the brake pads and replace as necessary. Inspect the rotor for damage and have it turned or replace it. If after replacing the pads/rotors, if the brake pedal slowly goes down when applying the brakes, replace the master cylinder.


Why won't your brake lights go off after parking?

There is a brake light switch on the back side of the brake pedal some times they stick with wear inspect that first.


What is the bhp of a Subaru?

The Brake Horse Power of a Subaru is dependent upon many factors, such as year, model, trim, and modifications (if applicable).


Do you have a 100000 mile tuneup checklist for an 02 Lexus ES300?

Check Vehicle (S) While driving the vehicle, check the proper operation of the engine, transmission, brakes and steering. Ch Inspect Ball Joint Inspect ball joints and dust covers for cracking and wear. Brake Hose/Line Inspect brake lines and hoses for chafing, cracks, deterioration and leakage. Brakes and Traction Control Inspect brake linings and drums/discs. Check parking brake operation and brake pedal free-play. Constant Velocity Joint Boot Inspect driveshaft boots and retorque flange bolts. Drive Belt Exhaust System Fluid - Differential Check fluid level and condition.Paint Inspect body for corrosion and paint condition.Steering Inspect the vehicles steering linkages. Steering Gear Inspect rack and pinion assembly for leakage.Replace Cabin Air Filter If equipped. Engine Oil Oil Filter, Engine Rotate Tires