0
The air conditioner will not work in a '93 crown Victoria if it was the heater valve what would cause it to malfunction and where is it located?
Wiki User
∙ 13y ago
Improved Answer
Actually it is located lying loose on top of the RH valve cove,r spliced into the heater hose. But this valve only controls the heater in HEAT mode and has no control over the A/C whatsoever
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Where is the heater core located on 2001 Crown Victoria?
Behind the dash on the passenger side.
Where is the air conditioner filter located on a home system?
Inside the heater/ac unit close to the main unit.
Where is the rear defrost timer located in a 1987 ford crown Victoria?
on the back side of the heater control panel
Where is the air conditioner evaporator located in a 2007 Chevrolet impala ls?
Behind the heater core in the HVAC assembly. The assembly is behind the radio.
Signs of bad air conditioner thermostat?
The air conditioner or heater continually runs.
Would a house in devonport most likely need a heater or an air conditioner?
the answer is air conditioner
What controles heater air conditioner tem 93 s10?
The temp blend door. It is electrically controlled by an actuator. It is located behind the dash assembly.
What controls the temperature on the air conditioner and heater?
BIOSPHERE
Should the air conditioner unit come on when the heater is blowing?
If your heater is a heat pump , then yes.
What does code po135 means on 1999 Toyota camery?
Heated oxygen sensor heater circuit malfunction (bank 1, sensor 1): Open or short in heated oxygen sensor heater circuit Heated oxygen sensor heater malfunction (Haynes Repair Manual)
Nissan exterra air conditioner and heat only work on 4?
heater resistor burnt out! Located under glovebox near heater motor.(held in with 2 screws) 4 to 6 wires coming from the resistor.
What causes an 02 heater circuit malfunction on a 2000 Maxima SE?
Newer oxygen sensors are heated for accuracy. If the heater element goes bad the oxygen sensor doesn't work and needs to be replaced. If you have an oxygen sensor heater malfunction, it just means that the oxygen sensor has failed.
