In a car thermostat the element is wax
In heat.Because iron absorbs heat.
Only if they are controlled by the same thermostat. If there are two thermostats, they will operate independently.Funny I was under the impression with probe in water to determine temperature one would have used an AQUA Stat
transmutation - same as the alchemists called it.
yes
The normal temperature is 20 deg C - irrespective of the element or compound under consideration.
Temperature or pressure.
A thermostat on the wall measures air temperature to control a gas or electric heating (or air conditioning) system.A thermostat in a clothes iron measures the temperature of the metal ironing plate to control the electrical heating element in the clothes iron.
It is the temperature at which the element will change state from a solid into a liquid. Note that the temperature actually changes depending on pressure. When no pressure is given assume 1 atmosphere.
Incubators are used in Biology, hospitals, and agriculture for hatching eggs. An incubator has a thermostat that is turned on to a specific temperature and when the temperature goes below the set temperature, the heating element comes on.
a phase temperature is a shifting of an element from one form to anothwer
The wattage of electric base board heaters does not change because the thermostat is set on low. The wattage is a fixed value on the heater because of its internal resistance element. The thermostat set on low shuts off at a lower temperature than a thermostat that is set on high. It is the time interval that governs the amount of heat that the heater produces when the thermostat calls for heat. Once the room heats up to the temperature that the thermostat is set at, the heater shuts off. The thermostat is just a temperature switch.
The thermostat on a 2005 Honda Element is located near the radiator where the hose meets the engine block. The cap and thermostat is all one piece.
A heat detector is connected to a fire alarm system. It is designed to respond when the heat sensitive element has increased temperature due to a fire.
because it is radiation and radiation can not be affected by temperature and/or concentration.
yes the element changes when the atomic mass changes
Copper is the cheapest and widely used element in wiring. Copper alloys are also used for the long run, increase flexibility and better handle of temperature changes.
Any element can be used to measure temperature.