If the oil light comes on but the oil level is ok, the problem may be a faulty sending unit, as it turned out in my case.
how do i fix the problem if the tcl light comes on in a 2003 mitsubishi galant
Remove the upper corner screws first, and then the lower bottom screws second with a Phillips screwdriver. The lower bottom screws are hidden underneath the two square plastic tabs (caps)...you just need to pry them off with a flathead screwdriver, and then you'll have access to the two screws that's holding the instrument cluster lens. I found out myself by trial and error, nobody told me. This is how you reset the red "maint req'd" light that comes on after a preset mileage to remind you to service your Mitsubishi Mighty Max pickup truck. I own a 1991 Mighty Max myself and I perform all routine maintenance on it....I hope this pointer helps.
is your "NO CHARGE" warning light coming on? if not this could simply be the problem, on some vehicles the charging circuit incorperates the "NO CHARGE" bulb and if its blown the vehicle wont charge. COuld be an alternator problem ( worn bushes etc) or faulty earth lead from alternator.
Normally it means the alternator is defective.
Disconnect battery, if light comes back on you need to get the code read and repair the error.
The light comes on when the computer has detected a malfunction and sets a code.
52 miles till empty
about 7 feet.
It is a warning light for front brake pad wear. It comes on when there is about 3-4mm of pad material left.
send me your problem exactly : Is the light comes on when you drive more than 30 km is it comes when put 4wd mrirbid@yahoo.com
8.5 liters about 50 miles
where is dash light and tail light relay on 1984 nissan pickup truck