0
What else can I help you with?
Wear are the timing marks on 1996 Pontiac Sunfire 2.2L ENGINE?
WHERE is the timing mark on Pontiac sunfire 2.2l
Where is the timing mark on a Pontiac 326 v8 engine?
on the harmonic balancer.
Where should your timing mark be on a Pontiac 326?
It is located on the harmonic balancer.
What is the timing mark on a 1967 Pontiac 400?
6 degrees BTDC
Where is the timing mark on 1.6 liter 1988 Pontiac Lemans?
The marks are on the timing belt cover,and on the pulley for the crank.
Where are the timing marks on a 97 Grand Am 3100?
i will like to know where is the mark on a grand am 3100 grand am thx
How do you change the Timing Belt in a 1999 Daewoo Laganza?
look at how to set timing mark for 99 daewoo,explained it there
Where should the timing marks be when installing a timing chain set in a 1966 Pontiac 389?
The timing mark on the top gear should be at 06:00, while the timing mark on the bottom gear should be at 12:00. IOW, they "point to each other" Good luck!
What is the point gap dwell and timing mark on a1965 Pontiac GTO 389 cubic engine with three two barrel carburtors?
Dwell=30. Timing +6
How do you fix the timing on a 1990 Pontiac grand prix le 3.1 6 cylinder?
To fix the timing on a 1990 Pontiac Grand Prix LE with a 3.1L V6 engine, first ensure the engine is at TDC (Top Dead Center) on the compression stroke for cylinder #1. Then, check the timing mark on the harmonic balancer against the timing tab on the engine; it should align with the specified degree (usually around 0 degrees). If it doesn't, loosen the distributor hold-down bolt and rotate the distributor slightly until the marks align. Finally, tighten the distributor bolt and recheck the timing to ensure it's set correctly.
How do you set timing marks on 1999 Toyota Camry engine 4-cylinders?
The mark on the camshaft should be aligned with the mark on the crankshaft.
How do you Align timing marks 94 Pontiac sunbird?
there should be markings on your timing cover that range from 0 to 16, the flywheel mark needs to be in the center at 8. then the cam pulley mark needs to line up with the groove on the backing plate.
