up under the dash by your right knee.
No
how do you reset the check engine light on a 2005 Toyota tundra
In most cases the Toyota tundra factory alarm will reset itself after 10 minutes. You can also pull the fuse out for 10 seconds and replace it to reset the alarm.
To reset the dash light indicators on a Toyota Tundra the trucks ECU will need to be reset. The simple way of resetting the ECU requires disconnecting the battery for 5 seconds. When the ECU is reset the lights will be clear.
deflate them
On a 2006 Toyota Tundra, the low tire pressure reset button is typically located under the dashboard, near the steering column. It may also be found near the driver's side footwell. To reset the tire pressure warning light, make sure all tires are properly inflated, then press and hold the reset button until the light blinks and turns off.
The reset button for the tire pressure monitor light on a 2008 Toyota Tundra is typically located beneath the steering wheel, near the driver's side footwell. To reset the light, press and hold the button until the TPMS light blinks three times, then release it. If the light does not turn off, ensure that all tires are properly inflated and check for any issues with the tire pressure monitoring system.
Toyota does not use inertia/reset switches.
Here is the link on how to reset and change engine oil on 08 tundra ( http://www.tundraheadquarters.com/documents/toyota-tundra-5-7-liter-oil-change.pdf )
it does not have an inertia switch.
To disable the low tire pressure light on a 2007 Toyota Tundra, first, ensure that all tires are properly inflated to the recommended pressure. Then, turn the ignition to the "ON" position without starting the engine. Press and hold the tire pressure warning reset button, usually located under the steering wheel, until the light blinks three times, indicating that the system has been reset. Finally, turn off the ignition and start the engine to see if the light has turned off.
The oil pressure switch does NOT have a reset.