0
To increase the rate of solution of a solid in water what do you do?
Wiki User
∙ 10y ago
The process of dissolving is and can be aided by stirring, swirling, or shaking. However there are other factors which can determine the rate a solute dissolves in a solvent. One such factor is temperature. Example: sugar dissolves faster in hot tea rather than in cold..
Wiki User
∙ 15y ago
Wiki User
∙ 10y agoincrease the pressure over the water.
Add your answer:
Earn +20 pts
How do the methods of speeding the rate of solution for dissolving a solid in a liquid compare to the methods of speeding the rate of solution when dissolving a gas in a liquid?
Heat (in most cases) has an opposite effect on the solubility of solids as compared to gases. Almost all solids will dissolve faster in a liquid at higher temperatures, whereas gases will dissolve in a liquid faster at lower temperatures (as long as the temperature is not so low that the liquid in question freezes).
Why does crushing help a solid solute dissolve?
The rate of dissolution of a solid is dependent on the surface area reaction. By crushing the cube, the surface area is greatly increased, thus increasing the rate of dissolution.
You make ammonia in a factory and a large order just arrived. To increase your rate of production or rate of the reaction to produce ammonia you can do what?
The most effective way is to increase the pressure. You will already be using a catalyst, and increasing the temperature will increase the rate, but slow down the achievement of equilibrium so will not solve your problem.
What effect dose temperature have on reaction rate?
It depends on the original temperature, but the rule of thumb is that near normal room temperature, raising the temperature by ten degrees will roughly double the reaction rate.
What is the effect of the temperature on the flow rate and the viscosity of a liquid?
HSP With increase in temp.the viscosity of liquids decreases,thereby increasing the flow rate and vice versa.The decrease in viscosity with rising temp.is due to the fact that the intermolecular attraction decreases and the cohesive forces increases. This does not apply with water
Why is the solution boiled after adding excess hydrochloric acid to the solid hydrate?
to remove carbondioxide from the solution and also to increase the rate of reaction
What will affect both the rate of dissolving and the solubility of a solid in a liquid?
Heating or stirring will normally increase the rate at which a soluble solid dissolves in liquid. Heating will also normally increase the amount of solute that can be retained in solution.
How can you increase the rate of dissolution?
One way is to grind up solid, or increase the temperature. Also, you can stir the solution, and then, there are enzymes.
Not increase the rate at Which a solid dissolves?
Decreasing temperature would not increase the rate at which a solid dissolves
Would not increase the rate at which a solid dissolves?
Decreasing temperature would not increase the rate at which a solid dissolves
What affects both the rate of solution and the solubility of a solid in a liquid?
Temperature affects both the rate of solution and the solubility of a solid in a liquid
Which of the following does not increase the rate of dissolving a solid in water?
- a decrease in temperature - an increase of the particles dimensions - lack of stirring
What would decrease the rate of solution when dissolving a solid in water?
By irritating a solution, increasing the concentration of the solute, by increasing the temperature
How do you increase the rate of a reaction of a solid?
Grinding the solid into a powder increases the surface area and increases the rate of the reaction. Heating it would also increase the rate.
What are three ways to increase the dissolving rate of sugar in water?
Try heating the solution or add more of water
Increased temperature will increase?
rate of solution
One way to increase the rate of reaction occurring in a solution is to stir the solution How does this increase the rate of the reaction?
It increases the number of collisions between molecules.
