0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you check the 4-wheel drive fluid on a 1999 Jeep Cherokee Laredo?
under the jeep your transfer case remove the bolt with an Allen hole in it with and Allen socket. the fluid should run out of the hole. if you remove the bottom bolt you will drain your transfer case. if you remove the top bolt then you will be able to check it and will not have to refil it.
How do you remove the starter from your 71 Mercedes 280SE?
plate in floor next to footrest (RHD) - ALLEN KEY -TOP BOLT - BOTTOM BOLT FROM UNDER THE CAR
How do you check transmission fluid on 2003 road king?
remove Allen head /dip stick in top of trans,just below oil tank.the dip stick looks like a large Allen head bolt.
Replace struts on 2003 town and country?
You will need to compress the strut spring with a spring compressor. When the strut spring is compressed remove the strut retaining bolts. There is a strut retaining bolt on the top and the bottom of the strut assembly. Reverse the process to install the new strut.
How does one remove the bolt from the breech of a Remington model 740 Woodmaster?
Removing the bolt handle is a bit involved. If you slide the ejection port dust cover back and forth slightly until the cut-out on the top of the dust cover is over the bolt handle top you will see the end of a pin. This pin holds the bolt handle in place in the bolt. Unless you have the ability to completely take-down this rifle and then re-assemble it to working order, and have the tools to do so, it is NOT recommended you remove the bolt handle retaining pin.
Where is the micro-filter on a 2006 525i?
There are two, located in each of the top corners under the bonnet. Unscrew the retaining bolt (13mm) and unclip the holders to remove. Will take less than a minute each.
How do you remove the fuel pump from a 1997 suburban I already have the gas tank lowered but cannot figure how to remove it from the top there are no screws?
There is a retaining ring that spins on and off. There is a retaining ring that spins on and off. There is a retaining ring that spins on and off.
How do you remove the ignition lock cylinder on a 1994 Grand Am?
The 1994 Pontiac Grand Am ignition lock cylinder is held in place by the retaining ring at the top of the cylinder. Remove the retaining ring. Remove the wiring harness from the back of the cylinder.
How do you change rear oil in ford ranger?
there should be a drain bolt on the lower front or rear section and a bolt on the top remove the top bolt and put the drain bolt on the bottom back in and fill the case from the top bolt untill fluid runs out and screw top bolt back in and hit the road
How do you remove the rear radio panels on a ck 3500 crew cab?
The Chevrolet 3500 rear radio panels are held in place with retaining clips. There will be a retaining clip on the top and the bottom of each panel. Pry outward on each retaining clip to remove the panel.
How can you remove the coolant overflow container in a 4 Runner The top of the front bolt on the battery clamp is broken and you need to get at the bottom of the bolt to get it out?
Use a bolt extractor to remove the broken battery bolt..This is the easiest way...
How do you adjust clutch on a 1.8 diesel escort van 2002?
There is an Allen key bolt at the top of the clutch pedal.
