P0300 Diagnostic Code - Random Misfire
Symptoms.
Engine may stumble or miss
Engine may be hard to start
you may notice no issues
Cause
Failing spark plugs or spark plug wires
Bad coil or coil pack
Failing oxygen sensor(s)
Bad fuel injector or more than one
Stuck exhaust valve
Bad catalytic converter
EGR valve or valve passage clogging
Bad camshaft position sensor
Bad PCM or ECM
The Fix
Best first action is a tune up, new plugs, wires, inspect all hoses and wire connections then reset the code. If it returns you will need to narrow it down to a system, coils and coil packs should be tested, catalytic converters for function ( do you smell rotten eggs?). A misfire that jumps cylinders could indicate a lean condition, do you have any other codes along with the 300? this will help clue you in to the source, check valve function to make sure they are opening and closing fully.
This is probably pone of the most difficult codes to troubleshoot, so start with the basics and work your way into the more expensive options, in many cases a good old tune up solves the problem, back it up with a fuel system cleaning and see where you stand.
It's a misfire that's not in just one cylinder.
Trouble code P1582 means: Idle Adaptation at Limit
Trouble code P1684 means: The battery has been disconnected within the last 50 starts
Trouble code P1167 means: LAMBDA CON.AT L/R LIMIT-B2
One way would be for the check engine light to illuminate and spit out a code P0300 for a random misfire.
I have a Haynes repair manual for my 92 caddy sedan deville which explains that your error code is an ECM trouble code, torque converter clutch (tcc) engadgment fault. I don't know what it means but I hope it helps u!!
P0700 is transmission code present. It means that the transmission computer has set one or more trouble codes. You will need to have the transmission computer scanned to know the codes and possible causes.
i don't know what is referrer code///
as far as I know code 35 is cooling fan problem.
take it to autozone they will pull the code out of your car for you for free and let you know what the code means take it to autozone they will pull the code out of your car for you for free and let you know what the code means
Trouble code P1383 means: Camshaft Position Timing Over Retarded (Bank 1) Replace the camshaft sensor
That means that the trans computer has detected a problem and put the trans in limp in. You need to have the system checked for trouble codes to know what the cause could be. When you get the code you can ask a new question with the code, year, make, and model.
Transmission code present. You need to check the TCM for codes to know possible causes.